hn58x2502fpie Renesas Electronics Corporation., hn58x2502fpie Datasheet - Page 8

• Manufacturer Part Number: hn58x2502fpie
• Description: Serial Peripheral Interface Electrically Erasable And Programmable Read Only Memory
• Manufacturer: Renesas Electronics Corporation.

HN58X2502I/HN58X2504I
Pin Function
Serial data output (Q)
This output signal is used to transfer data serially out of the device. Data is shifted out on the falling edge of serial
clock (C).
Serial data input (D)
This input signal is used to transfer data serially into the device. It receives instructions, addresses, and the data to be
written. Values are latched on the rising edge of serial clock (C).
Serial clock (C)
This input signal provides the timing of the serial interface. Instructions, addresses, or data present at serial data input
(D) are latched on the rising edge of serial clock (C). Data on serial data output (Q) changes after the falling edge of
serial clock (C).
Chip select (S)
When this input signal is high, the device is deselected and serial data output (Q) is at high impedance. Unless an
internal write cycle is in progress, the device will be in the standby mode. Driving chip select (S) low enables the
device, placing it in the active power mode. After power-up, a falling edge on chip select (S) is required prior to the
start of any instruction.
Hold (HOLD)
The hold (HOLD) signal is used to pause any serial communications with the device without deselecting the device.
During the hold condition, the serial data output (Q) is high impedance, and serial data input (D) and serial clock (C)
are don’t care. To start the hold condition, the device must be selected, with chip select (S) driven low.
Write protect (W)
This input signal is used to protect the memory against write instructions. When write protect (W) is held low, write
instructions (WRSR, WRITE) are ignored. No action on this signal can interrupt a write cycle that has already started.
Rev.2.00, Jul.05.2005, page 8 of 20