s71pl129ja0 Meet Spansion Inc., s71pl129ja0 Datasheet - Page 50

no-image

s71pl129ja0

Manufacturer Part Number
s71pl129ja0
Description
Stacked Multi-chip Product Mcp Flash Memory And Psram 128 Megabit 8m X 16-bit Cmos 3.0 Volt-only Simultaneous Operation, Page Mode Flash Memory With 64/32/16 Megabit 4m/2m/1m X 16-bit Pseudo-static Ram
Manufacturer
Meet Spansion Inc.
Datasheet
50
Erase Suspend/Erase Resume Commands
Not es:
1. See
2. See
The Erase Suspend command, B0h, allows the system to interrupt a sector erase
operation and then read data from, or program data to, any sector not selected
for erasure. The bank address is required when writing this command. This com-
mand is valid only during the sector erase operation, including the 80 µs time-out
period during the sector erase command sequence. The Erase Suspend command
is ignored if written during the chip erase operation or Embedded Program
algorithm.
When the Erase Suspend command is written during the sector erase operation,
the device requires a maximum of 35 µs to suspend the erase operation. How-
ever, when the Erase Suspend command is written during the sector erase
time-out, the device immediately terminates the time-out period and suspends
the erase operation. Addresses are “don’t-cares” when writing the Erase suspend
command.
After the erase operation has been suspended, the bank enters the erase-sus-
pend-read mode. The system can read data from or program data to any sector
not selected for erasure. (The device “erase suspends” all sectors selected for
erasure.) Reading at any address within erase-suspended sectors produces sta-
tus information on DQ7–DQ0. The system can use DQ7, or DQ6 and DQ2
together, to determine if a sector is actively erasing or is erase-suspended. See
“Write Operation Status”
After an erase-suspended program operation is complete, the bank returns to the
erase-suspend-read mode. The system can determine the status of the program
timer.
Table 12
“DQ3: Sector Erase Timer”
for erase command sequence.
No
on page 56 for information on these status bits.
Figure 5. Erase Operation
Command Sequence
Data Poll to Erasing
Erasure Completed
Bank from System
A d v a n c e
Write Erase
Data = FFh?
(Notes 1, 2)
S29PL129J for MCP
START
on page 61 for information on the sector erase
Yes
I n f o r m a t i o n
Embedded
Erase
algorithm
in progress
S29PL129J_MCP_00_A0 June 4, 2004

Related parts for s71pl129ja0