w83c554f Winbond Electronics Corp America, w83c554f Datasheet - Page 18

• Manufacturer Part Number: w83c554f
• Description: System I/o Controller With Pci Arbiter & Ultradma/33 Ide Controller
• Manufacturer: Winbond Electronics Corp America

W83C554F
WINBOND ELECTRONICS CORP. AMERICA
Pin Name
PCI5TH# /
GNT3#
REQ3#
GNT4# /
FLSHREQ#
REQ4# /
FLSHACK#
PWRPC/X86#
/ CPUGNT#
CPUREQ#
Pin #
13
15
6
7
8
9
Table 2-3 (continued). PCI Arbiter Signals
Input/
Output
Input/
Output
Input
Output
Input
Input/
Output
Input
Description
When the on-chip PCI arbiter is enabled, GNT3# behaves as a
normal PCI grant output.
If a 2.2K ohm resistor straps this pin to ground, pin 6 and 7 function
as GNT4# and REQ4# after power-up. If this pin is weakly
strapped to VCC, pin 6 and 7 function as FLSHREQ# and
FLSHACK# after power-up. The PCI5TH# function is overridden
by the ARBDIS# function (i.e., if the on-chip PCI arbiter is
disabled, pin 6 and 7 function as FLSHREQ# and FLSHACK# no
matter how PCI5TH# is strapped.)
When the on-chip PCI arbiter is enabled, REQ3# behaves as a
normal PCI request input.
This is a multifunction pin, which is alternately used to request
flushing all buffers or granting PCI access to an external master. See
register offset 4Eh for configuration. If a 2.2K ohm resistor straps
this pin to ground, pin 6 and 7 function as GNT4# and REQ4# after
power-up. If this pin is weakly strapped to VCC, pin 6 and 7
function as FLSHREQ# and FLSHACK# after power-up.
This is a multifunction pin which is alternately used as flush
acknowledge or as a PCI access request input. See register offset
4Eh for configuration. If a 2.2K ohm resistor straps this pin to
ground, pin 6 and 7 function as GNT4# and REQ4# after power-up.
If this pin is weakly strapped to VCC, pin 6 and 7 function as
FLSHREQ# and FLSHACK# after power-up.
This multifunction pin is sampled by the W83C554F, following the
PWRGD active edge. If a 2.2K ohm resistor is weakly pulling this
pin to VCC at this time, the W83C554F is in PowerPC mode. If a
weak pull down resistor is connected to ground, the chip is in x86
mode.
When the PCI arbiter within the W83C554F is enabled (pin 16
Arbdis#/GNT2# is weakly pulled high), this pin functions as the
CPU Grant output which allows the system CPU-to-PCI bridge to
have access to PCI.
This input allows the system CPU to request access to the PCI bus
in systems with the PCI arbiter within the W83C554F enabled.
Pin Descriptions
16