kac-9637 ETC-unknow, kac-9637 Datasheet - Page 33

• Manufacturer Part Number: kac-9637
• Description: Cmos Image Sensor 648 H X 488 V Vga 68 Fps Monochrome Cis
• Manufacturer: ETC-unknow

IMAGE SENSOR SOLUTIONS
Register Set
Register Name Video Output Tristate Adjustment Register
Address
Mnemonic
Type
Reset Value
Register Name Initialization Register 1
Address
Mnemonic
Type
Reset Value
Register Name Pixel Offset Register
Address
Mnemonic
Type
Reset Value
www.kodak.com/go/imagers 585-722-4385
7:5
4
3
2
1
0
7:0
7:0
Bit
Bit
Bit
Tristate
VsOverride
HsOverride
PclkOverride
ExtSyncOver-
ride
PixCal
PixelOffset
Bit Symbol
Bit Symbol
Bit Symbol
55 Hex
DVBUSCONFIG3
Read/Write
00 Hex.Register Set (continued)
80 Hex
INITREG1
Read/Write
00 Hex.
83 Hex
PIXELOFFSET
Read/Write
1E Hex.
(continued)
Reserved
Digital output tristate. Set this bit
to 1 to tristate all digital outputs.
(vsync,
external sync). Use can override
this setting with independent
override bits.
Overrides tri-stating of Vsync
port in master timing mode. To
enable override, set bit to 1.
Overrides tri-stating of Hsync
port in master timing mode. To
enable override, set bit to 1.
Overrides tri-stating of Pclk port
in master timing mode.
enable override, set bit to 1.
Overrides tri-stating of external
sync port in master timing
mode. To enable override, set
bit to 1.
Write 5 Hex to enable the pixel
offset calibration circuits.
Notes:
This
accessed when the Int2 param-
eter in the INTREG2 register is
set to 01Hex.
PixCal should be reset to 00Hex
at the end of the pixel offset cal-
ibration procedure (see section
7.1 for more details).
Use to compensate for the sen-
sors natural pixel offset. See
section 7.1 for more details.
register
Description
Description
Description
hsync,
can
pclk,
only
data,
be
To
33
Register Name Power Down Control Register
Address
Mnemonic
Type
Reset Value
Register Name Initialization Register 2
Address
Mnemonic
Type
Reset Value
7:0
7:0
Bit
Bit
Patrol
Int2
Bit Symbol
Bit Symbol
85 Hex
POWCTRL
Read/Write
81 Hex.
88 Hex
INITREG2
Read/Write
00 Hex.
Write 82Hex before power down
to minimize the sensor’s power
down current.
Write 81Hex after power up
from the power down mode to
ensure correct operation of the
sensor.
Refer to section 9.2 for more
information.
Write 1 Hex to activate the sen-
sor’s initialization registers
Write 0 Hex to disable the sen-
sor’s initialization registers.
Note this register is used for
• the pixel array offset calibra-
• power/up and down of the
tion (section 7.2)
array (section 8.2)
Email:[e-mail]
Description
Description