MC68HC12 MOTOROLA [Motorola, Inc], MC68HC12 Datasheet - Page 356

• Manufacturer Part Number: MC68HC12
• Description: The MC68HC912DT128A microcontroller unit (MCU) is a 16-bit device composed of standard on-chip peripherals including a 16-bit central processing unit
• Manufacturer: MOTOROLA [Motorola, Inc]

MSCAN Controller
18.13.6 msCAN12 Receiver Flag Register (CRFLG)
Technical Data
356
CRFLG
$0104
RESET
W
R
NOTE:
WUPIF
Bit 7
0
The bit time is determined by the oscillator frequency, the baud rate
prescaler, and the number of time quanta (Tq) clock cycles per bit (as
shown above).
The CBTR1 register can only be written if the SFTRES bit in CMCR0 is
set.
All bits of this register are read and clear only. A flag can be cleared by
writing a 1 to the corresponding bit position. A flag can only be cleared
when the condition which caused the setting is no more valid. Writing a
0 has no effect on the flag setting. Every flag has an associated interrupt
enable flag in the CRIER register. A hard or soft reset will clear the
register.
WUPIF — Wake-up Interrupt Flag
RWRNIF — Receiver Warning Interrupt Flag
1. RWRNIF = (96 < REC) & RERRIF& TERRIF & BOFFIF
RWRNIF
If the msCAN12 detects bus activity while it is in SLEEP Mode, it
clears the SLPAK bit in the CMCR0 register; the WUPIF bit will then
be set. If not masked, a Wake-Up interrupt is pending while this flag
is set.
This bit will be set when the msCAN12 goes into warning status due
to the Receive Error counter (REC) exceeding 96 and neither one of
the Error interrupt flags or the Bus-Off interrupt flag is set
masked, an Error interrupt is pending while this flag is set.
6
0
0 = No wake-up activity has been observed while in SLEEP Mode.
1 = msCAN12 has detected activity on the bus and requested
0 = No receiver warning status has been reached.
1 = msCAN12 went into receiver warning status.
wake-up.
TWRNIF
5
0
MSCAN Controller
RERRIF
4
0
TERRIF
3
0
BOFFIF
MC68HC912DT128A — Rev 4.0
2
0
OVRIF
1
0
(1)
MOTOROLA
. If not
Bit 0
RXF
0