P82B96T PHILIPS [NXP Semiconductors], P82B96T Datasheet - Page 24

no-image

P82B96T

Manufacturer Part Number
P82B96T
Description
Dual bidirectional bus buffer
Manufacturer
PHILIPS [NXP Semiconductors]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
P82B96T
Manufacturer:
NXP
Quantity:
34
Part Number:
P82B96TD
Manufacturer:
NXP Semiconductors
Quantity:
27 208
Part Number:
P82B96TD
Manufacturer:
NXP
Quantity:
100
Part Number:
P82B96TD
Manufacturer:
NXP
Quantity:
1 000
Part Number:
P82B96TD
Manufacturer:
PHILIPS
Quantity:
1 000
Part Number:
P82B96TD
Manufacturer:
PHI
Quantity:
35
Part Number:
P82B96TD
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
P82B96TD
0
Part Number:
P82B96TD,118
Manufacturer:
AD
Quantity:
8 566
Part Number:
P82B96TD,118
Manufacturer:
NXP
Quantity:
500
Part Number:
P82B96TD.118
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
P82B96TD/S410
Manufacturer:
NXP
Quantity:
28 000
Part Number:
P82B96TD/S900
Manufacturer:
TI
Quantity:
2 898
Part Number:
P82B96TD/S910
Manufacturer:
NXP/恩智浦
Quantity:
20 000
NXP Semiconductors
13. Soldering of through-hole mount packages
P82B96_6
Product data sheet
13.1 Introduction to soldering through-hole mount packages
13.2 Soldering by dipping or by solder wave
13.3 Manual soldering
For further information on temperature profiles, refer to Application Note AN10365
“Surface mount reflow soldering description” .
This text gives a very brief insight into wave, dip and manual soldering.
Wave soldering is the preferred method for mounting of through-hole mount IC packages
on a printed-circuit board.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing. Typical dwell time of the leads in the wave ranges from
3 seconds to 4 seconds at 250 C or 265 C, depending on solder material applied, SnPb
or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Fig 24. Temperature profiles for large and small components
temperature
MSL: Moisture Sensitivity Level
Rev. 06 — 31 January 2008
= minimum soldering temperature
maximum peak temperature
minimum peak temperature
= MSL limit, damage level
Dual bidirectional bus buffer
temperature
peak
stg(max)
© NXP B.V. 2008. All rights reserved.
P82B96
001aac844
). If the
time
24 of 28

Related parts for P82B96T