AT88RF1354_09 ATMEL [ATMEL Corporation], AT88RF1354_09 Datasheet - Page 4

• Manufacturer Part Number: AT88RF1354_09
• Description: 13.56 MHz Type B RF Reader Specification
• Manufacturer: ATMEL [ATMEL Corporation]

2.
2.1.
2.2.
4
Instruction Set
Table 1.
The AT88RF1354 Command Reference Guide document contains all of the detailed information required by a software
developer or embedded systems programmer to use the AT88RF1354 Instruction Set. See
AT88RF1354 Command Reference Guide (doc 5150x).
RF Communication Commands
The RF ON Command and RF OFF Command are used to enable and disable the 13.56 MHz RF Field transmitter.
The RF Field is turned on at the beginning of a transaction and off at the end, since ISO/IEC 14443 cards and tags are
powered by the RF Field.
The Poll Continuous Command or Poll Single Command is used to search for ISO/IEC 14443 cards in the RF Field
using the standard REQB/WUPB and Slot-MARKER commands. These commands automatically perform the
time-slot polling function described in ISO/IEC 14443 part 3, and return the response from the first card found to the
host microcontroller.
All other RF communication is performed with the TX Data Command. The RF command and data bytes to be
transmitted are sent by the host microcontroller with the TX Data Command to AT88RF1354. The bytes received from
the host are formatted into a Type B standard frame and transmitted on the RF communications channel, along with
the CRC. When a response is received from the card, the response frame is decoded by AT88RF1354 and the
resulting bytes are stored in SRAM buffer memory. If a CRC or frame format error is detected in the response, then bits
are set in the Error Register (EREG). After the entire frame has been decoded by AT88RF1354, the host
microcontroller reads the TX Data Response over the serial interface.
Reader Configuration Commands
The Read Register Command and Write Register Command are used to read and write the configuration and status
registers of the AT88RF1354. Both the Transmitter Register (TXC) and Receiver Register (RXC) must be configured
before any RF communication occurs.
The Sleep Command is used to put the AT88RF1354 into Standby Mode. In Standby Mode the internal circuitry is
placed in standby, and all internal clocks are stopped.
13.56 MHz Type B RF Reader Specification
Abort
Clear
Poll Continuous
Poll Single
Read Buffer
Read Register
RF OFF
RF ON
Sleep
TX Data
Write Buffer
Write Register
Command Name
Instruction Set Sorted by Command Name
Poll Continuously for Type B PICCs
Poll Once for Type B PICCs
Exit command in progress
Exit command in progress, Clear Buffer, Turn RF OFF
Read Data Buffer
Read Configuration Register
Turn off 13.56 MHz RF Field
Turn on 13.56 MHz RF Field
Activate standby mode
Transmit data to PICC and receive the response
Write data buffer
Write configuration register
All other command code values are not supported
Description
www.atmel.com
Code
$0D
$0E
$0B
$0A
$0C
$02
$01
$08
$07
$03
$09
$06
8547B–RFID–3/09
for the