ATA5771_09 ATMEL [ATMEL Corporation], ATA5771_09 Datasheet - Page 199

• Manufacturer Part Number: ATA5771_09
• Description: Microcontroller with UHF ASK/FSK Transmitter
• Manufacturer: ATMEL [ATMEL Corporation]

18.7.2
18.7.3
146
ATtiny24/44/84
Analog Noise Canceling Techniques
ADC Accuracy Definitions
Digital circuitry inside and outside the device generates EMI which might affect the accuracy of
analog measurements. If conversion accuracy is critical, the noise level can be reduced by
applying the following techniques:
An n-bit single-ended ADC converts a voltage linearly between GND and V
(LSBs). The lowest code is read as 0, and the highest code is read as 2
Several parameters describe the deviation from the ideal behavior:
• Offset: The deviation of the first transition (0x000 to 0x001) compared to the ideal transition (at
Figure 18-9. Offset Error
• Gain Error: After adjusting for offset, the Gain Error is found as the deviation of the last
0.5 LSB). Ideal value: 0 LSB.
transition (0x3FE to 0x3FF) compared to the ideal transition (at 1.5 LSB below maximum).
Ideal value: 0 LSB
a. Keep analog signal paths as short as possible. Make sure analog tracks run over the
b. Use the ADC noise canceler function to reduce induced noise from the CPU.
c. If any port pins are used as digital outputs, it is essential that these do not switch
analog ground plane, and keep them well away from high-speed switching digital
tracks.
while a conversion is in progress.
Output Code
Offset
Error
V
REF
Input Voltage
Ideal ADC
Actual ADC
n
-1.
REF
7701C–AVR–12/08
in 2
n
steps