932S805CGLF IDT [Integrated Device Technology], 932S805CGLF Datasheet - Page 17
![no-image](/images/no-image-200.jpg)
932S805CGLF
Manufacturer Part Number
932S805CGLF
Description
K8 Clock Chip for Serverworks HT2100 Servers
Manufacturer
IDT [Integrated Device Technology]
Datasheet
1.932S805CGLF.pdf
(19 pages)
IDT
The I/O pins designated by (input/output) on the ICS932S805
serve as dual signal functions to the device. During initial
power-up, they act as input pins. The logic level (voltage) that
is present on these pins at this time is read and stored into a
5-bit internal data latch. At the end of Power-On reset, (see
AC characteristics for timing values), the device changes the
mode of operations for these pins to an output function. In
this mode the pins produce the specified buffered clocks to
external loads.
To program (load) the internal configuration register for
these pins, a resistor is connected to either the VDD (logic 1)
power supply or the GND (logic 0) voltage potential. A 10
Kilohm (10K) resistor is used to provide both the solid CMOS
programming voltage needed during the power-up
programming period and to provide an insignificant load on
the output clock during the subsequent operating period.
Shared Pin Operation -
Input/Output Pins
ICS932S805C
K8 Clock Chip for Serverworks HT2100 Servers
®
K8 Clock Chip for Serverworks HT2100 Servers
Device
Pad
Programming
Header
Via to Gnd
Series Term. Res.
17
Figure 1 shows a means of implementing this function when
a switch or 2 pin header is used. With no jumper is installed
the pin will be pulled high. With the jumper in place the pin will
be pulled low. If programmability is not necessary, than only
a single resistor is necessary. The programming resistors
should be located close to the series termination resistor to
minimize the current loop area. It is more important to locate
the series termination resistor close to the driver than the
programming resistor.
8.2K W
2K W
Clock trace to load
Via to
VDD
1131D – 05/04/10