MAX1301BEUP+CAL Maxim Integrated, MAX1301BEUP+CAL Datasheet - Page 27

• Manufacturer Part Number: MAX1301BEUP+CAL
• Description: Analog to Digital Converters - ADC Intel R2 Customer special for MAX1301BEUP+
• Manufacturer: Maxim Integrated

Specifications of MAX1301BEUP+CAL

• Number Of Channels: 4/2
• Architecture: SAR
• Conversion Rate: 130 KSPs
• Input Type: Single-Ended/Differential
• Operating Supply Voltage: 4.75 V to 5.25 V
• Maximum Power Dissipation: 879 mW
• Number Of Converters: 1

Figure 19. 4–20mA Application
Figure 20. Bridge Application
DNL is the difference between an actual step width and
the ideal value of 1 LSB. A DNL error specification of
greater than -1 LSB guarantees no missing codes and
a monotonic transfer function.
Transition noise is the amount of noise that appears at a
code transition on the ADC transfer function. Conversions
performed with the analog input right at the code transi-
tion can result in code flickering in the LSBs.
8- and 4-Channel, ±3 x V
Differential Nonlinearity (DNL)
______________________________________________________________________________________
4–20mA INPUT
4–20mA INPUT
BRIDGE
250Ω
250Ω
Transition Noise
DIFFERENTIAL
LOW-OFFSET
AMPLIFIER
CH0
CH1
REF
Channel-to-channel isolation indicates how well each
analog input is isolated from the others. The channel-to-
channel isolation for these devices is measured by
applying a near full-scale magnitude 5kHz sine wave to
the selected analog input channel while applying an
equal magnitude sine wave of a different frequency to
all unselected channels. An FFT of the selected chan-
nel output is used to determine the ratio of the magni-
tudes of the signal applied to the unselected channels
and the 5kHz signal applied to the selected analog
input channel. This ratio is reported, in dB, as channel-
to-channel isolation.
REF
CH0
CH8
MAX1300
MAX1301
MAX1300
Serial 16-Bit ADCs
Multirange Inputs,
Channel-to-Channel Isolation
µP
µC
27