S-24CS16A0I-D8S1G Seiko Instruments, S-24CS16A0I-D8S1G Datasheet - Page 26

• Manufacturer Part Number: S-24CS16A0I-D8S1G
• Description: IC EEPROM 16KBIT 400KHZ 8DIP
• Manufacturer: Seiko Instruments

Specifications of S-24CS16A0I-D8S1G

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 16K (2K x 8)
• Speed: 400kHz
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-DIP
• Organization: 2 K x 8
• Interface Type: 2-Wire
• Maximum Clock Frequency: 0.4 MHz
• Access Time: 1 us
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 1.8 V
• Maximum Operating Current: 4 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: Through Hole
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 1.8 V, 5.5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

26
2-WIRE CMOS SERIAL E
S-24CS16A
8. Trap: E
9. Trap: E
10. Trap: Severe environments
When the E
operation is aborted.
When the E
data received normally before receiving the stop condition signal can be written.
When write data is input more than defined page size at page write operation, for example, S-24CS16A (which can be
executed 16-byte page write) is received data more than 17 byte, 8-bit data of the 17th byte is over written to the first
byte in the same page. Data over the capacity of page address cannot be written.
Absolute maximum ratings: Do not operate these ICs in excess of the absolute maximum ratings (as listed on the data
sheet). Exceeding the supply voltage rating can cause latch-up.
Operations with moisture on the E
occasions like picking the E
on E
Also attention should be paid in using on environment, which is easy to dew for the same reason.
2
PROM pin to prevent malfunction by short-circuit.
receiving the defined data value (less than 8-bit) to SCL pin
“page write”
2
2
PROM operation and write data in case that write data is input more than defined page size at
PROM operation in case that the stop condition is received during write operation before
2
2
PROM receives the stop condition signal after receiving 1 byte or more of data for “page write”, 8-bit of
PROM receives the stop condition signal compulsorily, during receiving 1 byte of write data, “write”
2
PROM up from low temperature tank during the evaluation. Be sure that not remain frost
2
PROM
2
PROM pins may occur malfunction by short-circuit between pins. Especially, in
Seiko Instruments Inc.
Rev.5.2
00