MT48V8M16LFB4-8 IT:G Micron Technology Inc, MT48V8M16LFB4-8 IT:G Datasheet - Page 46
![IC SDRAM 128MBIT 125MHZ 54VFBGA](/photos/7/22/72286/557-54-fbga_sml.jpg)
MT48V8M16LFB4-8 IT:G
Manufacturer Part Number
MT48V8M16LFB4-8 IT:G
Description
IC SDRAM 128MBIT 125MHZ 54VFBGA
Manufacturer
Micron Technology Inc
Type
Mobile SDRAMr
Specifications of MT48V8M16LFB4-8 IT:G
Format - Memory
RAM
Memory Type
Mobile SDRAM
Memory Size
128M (8Mx16)
Speed
125MHz
Interface
Parallel
Voltage - Supply
2.3 V ~ 2.7 V
Operating Temperature
-40°C ~ 85°C
Package / Case
54-VFBGA
Organization
8Mx16
Density
128Mb
Address Bus
14b
Access Time (max)
19/8/7ns
Maximum Clock Rate
125MHz
Operating Supply Voltage (typ)
2.5V
Package Type
VFBGA
Operating Temp Range
-40C to 85C
Operating Supply Voltage (max)
2.7V
Operating Supply Voltage (min)
2.3V
Supply Current
100mA
Pin Count
54
Mounting
Surface Mount
Operating Temperature Classification
Industrial
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
PDF: 09005aef807f4885/Source: 09005aef8071a76b
128Mbx16x32Mobile_2.fm - Rev. M 1/09 EN
10. READs or WRITEs listed in the Command (Action) column include READs or WRITEs with
11. Does not affect the state of the bank and acts as a NOP to that bank.
5. The following states must not be interrupted by any executable command; COMMAND
6. All states and sequences not shown are illegal or reserved.
7. Not bank-specific; requires that all banks are idle.
8. May or may not be bank-specific; if all banks are to be precharged, all must be in a valid
9. Not bank-specific; BURST TERMINATE affects the most recent READ or WRITE burst, regard-
INHIBIT or NOP commands must be applied on each positive clock edge during these states.
Refreshing starts with registration of an AUTO REFRESH command and ends when
met. After
state for precharging.
less of bank.
auto precharge enabled and READs or WRITEs with auto precharge disabled.
Accessing mode
Precharging all: Starts with registration of a PRECHARGE ALL command and ends
t
RFC is met, the SDRAM will be in the all banks idle state.
register:
Starts with registration of a LOAD MODE REGISTER command and
ends when
be in the all banks idle state.
when
t
46
RP is met. After
t
MRD has been met. After
Micron Technology, Inc., reserves the right to change products or specifications without notice.
t
RP is met, all banks will be in the idle state.
128Mb: x16, x32 Mobile SDRAM
t
MRD is met, the SDRAM will
©2001 Micron Technology, Inc. All rights reserved.
READs
t
RFC is