TC58FVB160FT-85 Toshiba, TC58FVB160FT-85 Datasheet - Page 16

• Manufacturer Part Number: TC58FVB160FT-85
• Description: IC FLASH 16MBIT 85NS 48TSOP
• Manufacturer: Toshiba

Specifications of TC58FVB160FT-85

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 16M (2M x 8 or 1M x 16)
• Speed: 85ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DATA PROTECTION
The TC58FVT160/B160A includes a function which guards against malfunction or data corruption.
Protection against Program/Erase Caused by Low Supply Voltage
V
case, Auto operation is not executed again when V
input is necessary to execute Auto operation again.
If V
Protection against Malfunction Caused by Glitches
shorter than 3 ns (Typ.) input on WE , CE or OE . However, if a glitch exceeding 3 ns (Typ.) occurs and the
glitch is input to the device malfunction may occur.
misinterpreted as part of a command sequence input and that the device will acknowledge it. In this case, even if
a proper command is input, the device may not operate. To avoid this possibility, clear the Command Register
before command input. In an environment prone to system noise, Toshiba recommend input of a software or
hardware reset before command input.
Protection against Malfunction at Power-on
V
device automatically resets the Command Register and enters Read Mode.
LKO
IL
To prevent malfunction at power-on or power-down, the device will not accept commands while V
If V
To prevent malfunction during operation caused by noise from the system, the device will not accept pulses
The device uses standard JEDEC commands. It is conceivable that, in extreme cases, system noise may be
To prevent damage to data caused by sudden noise at power-on, when power is turned on with WE = CE =
DD
and OE = V
. In this state, command input is ignored.
DD
> V
drops below V
LKO
, take corrective action to ensure that commands may be accurately input on the system side.
IL
, the device does not latch the command on the first rising edge of WE or CE . Instead, the
LKO
during an Auto Operation, the device will terminate Auto-Program execution. In this
DD
returns to recommended V
TC58FVT160/B160AFT/AXB-70,-10
DD
voltage. Therefore command
2004-09-01 16/42
DD
is below