SE97TP,147 NXP Semiconductors, SE97TP,147 Datasheet - Page 25

• Manufacturer Part Number: SE97TP,147
• Description: IC TEMP SENSOR DIMM 8-HWSON
• Manufacturer: NXP Semiconductors

Specifications of SE97TP,147

• Function: Temp Monitoring System (Sensor)
• Topology: ADC (Sigma Delta), Comparator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -40°C ~ 125°C
• Output Type: I²C™/SMBus™
• Output Alarm: Yes
• Output Fan: Yes
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-WSON (Exposed Pad), 8-HWSON
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-4730-2; 935286725147

NXP Semiconductors
Table 11.
SE97_7
Product data sheet
Bit
Symbol
Default
Access
Bit
Symbol
Default
Access
Configuration register (address 01h) bit allocation
CTLB
8.3 Configuration register (01h, 16-bit read/write)
R/W
15
R
0
7
0
Table 12.
Bit
15:11 RFU
10:9
AWLB
R/W
Symbol
HEN
14
R
0
6
0
Configuration register (address 01h) bit description
Description
When enabled, hysteresis is applied to temperature movement around trigger
points. For example, consider the behavior of the ‘Above Alarm Window’ bit
(bit 14 of the Temperature register) when the hysteresis is set to 3 °C. As the
temperature rises, bit 14 will be set to ‘1’ (temperature is above the alarm
window) when the Temperature register contains a value that is greater than the
value in the Alarm Temperature Upper Boundary register. If the temperature
decreases, bit 14 will remain set until the measured temperature is less than or
equal to the value in the Alarm Temperature Upper Boundary register minus
3 °C. (Refer to
Similarly, the ‘Below Alarm Window’ bit (bit 13 of the Temperature register) will
be set to ‘0’ (temperature is equal to or above the Alarm Window Lower
Boundary Trip register) when the value in the Temperature register is equal to or
greater than the value in the Alarm Temperature Lower Boundary register. As
the temperature decreases, bit 13 will be set to ‘1’ when the value in the
Temperature register is equal to or less than the value in the Alarm Temperature
Lower Boundary register minus 3 °C. Note that hysteresis is also applied to
EVENT pin functionality.
When either of the Critical Trip or Alarm Window lock bits is set, these bits
cannot be altered until unlocked.
reserved for future use; must be ‘0’.
Hysteresis Enable.
CEVNT
RFU
00 — disable hysteresis (default)
01 — enable hysteresis at 1.5 °C
10 — enable hysteresis at 3 °C
11 — enable hysteresis at 6 °C
R/W
13
R
0
5
0
Rev. 07 — 29 January 2010
DDR memory module temp sensor with integrated SPD, 3.3 V
Figure 8
ESTAT
R/W
12
R
0
4
0
and
Table
EOCTL
R/W
11
R
0
3
0
13).
R/W
CVO
R/W
10
0
2
0
HEN
R/W
R/W
EP
9
0
1
0
© NXP B.V. 2010. All rights reserved.
SE97
SHMD
EMD
R/W
R/W
8
0
0
0
25 of 55