DEMOBOARD TLE 6244X Infineon Technologies, DEMOBOARD TLE 6244X Datasheet - Page 37

• Manufacturer Part Number: DEMOBOARD TLE 6244X
• Description: BOARD DEMO FOR TLE 6244X
• Manufacturer: Infineon Technologies

Specifications of DEMOBOARD TLE 6244X

• Main Purpose: Power Management, Low Side Driver (Internal FET)
• Embedded: No
• Utilized Ic / Part: TLE6244
• Primary Attributes: 18 Channel Internal Switch
• Secondary Attributes: Overvoltage, Short-Circuit & Thermal Protection
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: DEMOBOARDTLE6244XIN

Final Data Sheet
1.11 Notes for the Application in Commercial Vehicles
1.11.1 Notes for short circuit limitation
For electric systems with 24V battery voltage, that can even increase to > _ 37V in case of
load dump, some peculiarities have to be observed!
The static voltage at pin UBatt without destruction is limited to 37V, therefore this pin must either
be connected to the 5V supply voltage VDD or else the voltage at pin UBatt has to be limited by
adequate external circuitry. By connecting pin UBatt to VDD the values of R
switches will increase up to 20%.
The power stages 7...18 are equipped with a 40V active clamping. Therefore this power stages
must only drive loads with an accordingly high resistance that can be switched on in case of over-
voltage (e.g. a maximum load dump voltage of 60V and a load resistor of 1k
dissipation of 0.8W for each power stage. For all of the 12 power stages together there is a power
dissipation of 9.6W for the typical duration of a load dump of 500ms.).
The restrictions listed above are no longer relevant in case of a „overvoltage-protected
battery voltage“within the 24V electric system that limits the voltage to e.g. a maximum of
37V.
The thresholds of the currents, on which the power stages are switched off in case of overload,
are increased by approximately 25% if there is a voltage at pin UBatt higher than19V (reason:
jump start requirements in 12V electric systems). Exception: OUT9 and OUT10 and OUT15...
OUT18. See characteristics in chapters 3.5.3, 3.6.3, 3.7.3 and 3.8.3.
The restrictions concerning overload of power stages (see 3.5.2, 3.6.2, 3.7.2 and 3.8.2) and per-
missible clamping energy (see 3.5.8, 3.6.8, 3.7.8 and 3.8.8) are relevant further on.
The power stages are short circuit protected for the following conditions:
The max. voltage at the output pins are limited to 36V and the TLE6244 is not operating in the
booster mode.
The power stages will be switched on/off with a max. frequency of 1 kHz.
Only a 40 msec burst with the 1 kHz on/off-frequency is allowed, with a minimum burst repetition
time of 1 sec. The maximum number of burst repetition cycles is 25. The number of driving cycles
under these conditions is limited to 100 in lifetime. The temperature of the slug of the MQFP64
package must not exceed 130°C.
These limitations are valid for UBatt > 24 V.
For Ubatt 24 V the number of driving cycles under these conditions is extended to 1000 in life-
time.
37
ds, on
result in a power
TLE 6244X
V4.2, 2003-08-29
of the power