DAK-16A Power Integrations, DAK-16A Datasheet - Page 7

• Manufacturer Part Number: DAK-16A
• Description: KIT DESIGN ACCELERATOR ADAPTER
• Manufacturer: Power Integrations
• Series: LinkSwitch®r

Specifications of DAK-16A

• Main Purpose: AC/DC, Primary Side
• Outputs And Type: 1, Isolated
• Power - Output: 2.75W
• Voltage - Output: 5.5V
• Current - Output: 500mA
• Voltage - Input: 85 ~ 265VAC
• Regulator Topology: Flyback
• Frequency - Switching: 42kHz
• Board Type: Bare (Unpopulated)
• Utilized Ic / Part: LNK500, LNK501, LNK520
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 596-1001

17-May-04
EPR-16 – LinkSwitch 2.75 W Charger/Adapter
3 Schematic
Figure 5 – EP-16 Low Cost, 2.75 W LinkSwitch Cell Phone Charger Schematic.
Optional components L2, C6 and R4 may be fitted to the board to improve radiated EMI.
The effect of these components is shown in the “Conducted EMI Results” section of this
document.
Optional component R3 may be fitted in place of L1 in applications where conducted EMI
is filtered externally (e.g. in an embedded system). In this case a 0 Ω resistor or jumper
should be used. In low power applications (less than approximately 1.5 W), a low value
resistor may be used to provide sufficient conducted EMI filtering. A value in the range of
0 Ω to 10 Ω may be used.
Power Integrations
Page 7 of 36
Tel: [phone] Fax: [phone]
www.powerint.com