DM300019 Microchip Technology, DM300019 Datasheet - Page 23

BOARD DEMO DSPICDEM 80L STARTER

DM300019

Manufacturer Part Number
DM300019
Description
BOARD DEMO DSPICDEM 80L STARTER
Manufacturer
Microchip Technology
Type
MCUr
Datasheets

Specifications of DM300019

Contents
Board, CD, Sample Part
Processor To Be Evaluated
dsPIC30F and dsPIC33F
Interface Type
RS-232
Silicon Manufacturer
Microchip
Silicon Core Number
DsPIC30F6014A, DsPIC33FJ256GP710
Silicon Family Name
DsPIC30F And DsPIC33F
Kit Contents
Development Board And Docs On CD
Rohs Compliant
Yes
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
dsPIC30F, dsPIC33F
Lead Free Status / Rohs Status
Lead free / RoHS Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
DM300019
Manufacturer:
Microchip Technology
Quantity:
135
Part Number:
DM300019
Manufacturer:
MICROCHIP
Quantity:
12 000
2.6
© 2006 Microchip Technology Inc.
PROGRAMMING THE CHIP
The MPLAB ICD 2 In-Circuit Debugger is used to program and debug the
dsPIC30F6014A device in-circuit on the dsPICDEM 80-Pin Starter Development
Board.
Use the procedures in the following section to program the dsPIC30F6014A device.
2.6.1
1. Use the Configure>Configuration Bits menu to display the configuration settings.
2. Set up the configuration bits, as shown in Figure 2-10.
FIGURE 2-10:
2.6.2
1. Connect the MPLAB ICD 2 to the PC with the USB cable (see Figure 2-11).
2. Connect the MPLAB ICD 2 to the dsPICDEM 80-Pin Starter Development Board
3. Apply power to the board.
Before you apply power to the board, observe these voltage precautions:
If a dsPIC33F device is being used, J5 should be OPEN or OFF to enable 3.3V to the V
or supply voltage. Operating a dsPIC33F device at 5.0V will cause a catastrophic failure
of the device.
If a dsPIC30F device is being used, J5 can be open or closed. You will get 3.3V or 5.0V
voltage to the V
Note:
The settings that will most likely need to change are:
with the short RJ-11 (telephone) cable.
Oscillator
Watchdog Timer
Set Up The Device Configuration
Connect the MPLAB ICD 2 In-Circuit Debugger
Before proceeding, make sure that the USB driver for the MPLAB ICD 2 has
been installed on the PC (see the “MPLAB
User’s Guide” (DS51331) for more details regarding the installation of the
MPLAB ICD 2).
DD
pin.
CONFIGURATION SETTINGS
XT w/PLL 4x
Disabled
CAUTION
®
ICD 2 In-Circuit Debugger
DS51584B-page 19
Tutorial
DD

Related parts for DM300019