STM3210B-EVAL STMicroelectronics, STM3210B-EVAL Datasheet - Page 27

• Manufacturer Part Number: STM3210B-EVAL
• Description: BOARD EVALUATION FOR STM32
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STM3210B-EVAL

• Contents: Fully Assembled Evaluation Board
• Processor To Be Evaluated: STM32F10x
• Data Bus Width: 32 bit
• Interface Type: USB
• Operating Supply Voltage: 5 V
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32F1xx
• For Use With/related Products: STM32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6048

UM0435
Date submenu
This submenu is divided into two items that allow the user to display or set the current date.
Figure 23. Setting the Year
Date Adjust: this item has to be selected after each power-up in order to set the
current date. If the time and date have not been configured before, a message is
displayed, that gives the choice to set the time and date or, to exit to the upper
submenu. The user is asked to set the current date to be stored in the application
memory. The date is displayed as Year, Month, Week Nbr, Day Nbr (number of the
day in the year) with the selected day shown in the month. There is no default date
since the user has to set the date at least once. Once the submenu has been selected,
the user starts by setting the Year, then the Month and the day of the selected month.
The Month and the Year are selected using the UP or DOWN push-button. For the day,
the UP, DOWN, RIGHT and LEFT push-buttons can be used. Pressing the UP push-
button will display the current value plus one, pressing the DOWN push-button will
display the previous value. To confirm the selected month, the user has to press the
SEL push-button and an automatic jump to the year configuration takes place. The
same procedure is applicable for the year configuration. After configuring the day,
pressing the SEL push-button will store the entered value and exit to the Date
submenu. The current date value is then shown and the user can change the setting if
required. The messages shown in
displayed on the LCD when this submenu is selected.
Doc ID 13534 Rev 5
Figure
23,
Figure 24
and
Running the demonstration
Figure 25
are successively
27/57