STM3210B-EVAL STMicroelectronics, STM3210B-EVAL Datasheet - Page 49

• Manufacturer Part Number: STM3210B-EVAL
• Description: BOARD EVALUATION FOR STM32
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STM3210B-EVAL

• Contents: Fully Assembled Evaluation Board
• Processor To Be Evaluated: STM32F10x
• Data Bus Width: 32 bit
• Interface Type: USB
• Operating Supply Voltage: 5 V
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32F1xx
• For Use With/related Products: STM32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6048

UM0435
4.2
Programming the M25P64 Flash memory
To program the Flash memory, go through the following steps:
1.
2.
3.
4.
Figure 62. Programming the Flash memory
Load the DFU firmware project using your preferred Toolchain and load the DFU image
using JTAG for the first time.
Connect the STM3210B-EVAL board to the PC with a USB cable. The first time this is
done, you will be asked to install a driver for the board. The driver is already available in
the installation directory.
Hold down the Key push-button on the STM3210B-EVAL board to enter the DFU mode.
Run the DfuSeDemo.exe program
In the Action (Select Target(s)) field, select SPI Flash: M25P64 and in the Upgrade
or Verify Action field, click on the Choose... button as shown in
Doc ID 13534 Rev 5
Demonstration programming using the DFU
Figure
62.
49/57