STM3210B-EVAL STMicroelectronics, STM3210B-EVAL Datasheet - Page 34

• Manufacturer Part Number: STM3210B-EVAL
• Description: BOARD EVALUATION FOR STM32
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STM3210B-EVAL

• Contents: Fully Assembled Evaluation Board
• Processor To Be Evaluated: STM32F10x
• Data Bus Width: 32 bit
• Interface Type: USB
• Operating Supply Voltage: 5 V
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32F1xx
• For Use With/related Products: STM32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6048

Running the demonstration
Note:
34/57
Standby mode menu
This menu allows the user to put the STM32F10xxx in the Standby mode. The software runs
the specific instruction sequence needed by the STM32F10xxx to enter the Standby mode.
In this application, the STM32F10xxx can be made to exit the Standby mode in two ways as
shown in
Figure 38. Entering the Standby mode
Figure 39. MCU in Standby mode
The MCU remains in the Standby mode until the Wake-up push-button is pressed. Once the
Wakeup push-button has been pressed, the MCU exits the Standby mode and the system
reset signal is generated.
if an RTC Alarm is generated while the MCU is in the Standby mode and the message
shown in
pressed to exit the Standby mode), the RTC Alarm causes the MCU to exit the Standby
mode and a system reset signal is generated.
In the first case, the Wakeup push-button is used to wake up the MCU from Standby
mode.
Once the Standby mode submenu has been selected, the red LEDs continue blinking
until the "SEL" push-button is pressed, and the system enters the Standby mode.
When the MCU is in the Standby mode, the message shown in
on the LCD
Figure
Figure 39
38.
is displayed (which means that the Wakeup push-button needs to be
To exit press Wakeup
MCU in Standby Mode
Exit: Wakeup Pin
STANDBY Mode
Exit: RTC Alarm
Doc ID 13534 Rev 5
Return
Figure 39
is displayed
UM0435