XE8000EV101 Semtech, XE8000EV101 Datasheet - Page 62

• Manufacturer Part Number: XE8000EV101
• Description: EVAL BOARD FOR XE8801AMI027LF
• Manufacturer: Semtech
• Type: MCUr

Specifications of XE8000EV101

• Contents: Fully Assembled Evaluation Board
• For Use With/related Products: XE88LC01AMI027
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

11.4 Interrupts and events map
11.5 Port A (PA) Operation
The Port A input status (debounced or not) can be read from RegPAin.
Debounce mode:
Each bit in Port A can be individually debounced by setting the corresponding bit in RegPADebounce. After reset,
the debounce function is disabled. After enabling the debouncer, the change of the input value is accepted only if
the input value is identical at two consecutive sampling on the rising edge of the selected clock. Selection of the
clock is done by the bit DebFast in Register RegSysMisc (see clock block documentation for more precision on
the frequency).
Pull-ups:
When the corresponding bit in RegPAPullup is set to 0, the inputs are floating (pull-up resistors are disconnected).
When the corresponding bit in RegPAPullup is set to 1, a pull-up resistor is connected to the input pin. Port A
starts up with the pull-up resistors disconnected.
Port A as an interrupt source:
Each Port A input is an interrupt request source and can be set on rising or falling edge with the corresponding bit
in RegPAEdge. After reset, the rising edge is selected for interrupt generation by default. The interrupt source can
be debounced by setting register RegPADebounce.
Note: care must be taken when modifying RegPAEdge because this register performs an edge selection. The
change of this register may result in a transition which may be interpreted as a valid interruption.
© Semtech 2005
CkDebounce
Interrupt source
Debounced
pa_irqbus[5]
pa_irqbus[4]
pa_irqbus[1]
pa_irqbus[0]
pa_irqbus[7]
pa_irqbus[6]
pa_irqbus[3]
pa_irqbus[2]
Input
RegIrqMid[5]
RegIrqMid[4]
RegIrqMid[1]
RegIrqMid[0]
RegIrqLow[7]
RegIrqLow[6]
RegIrqLow[3]
RegIrqLow[2]
the interrupt manager
Default mapping in
DebFast
Table 11-7: debounce frequency selection
0
1
Figure 11-2: digital debouncer
1
1
11-4
2
Clock filter
RegEvn[4]
RegEvn[0]
256 Hz
Default mapping in the
8 kHz
1
event manager
1
2
XE8801A – SX8801R
www.semtech.com