DEMO9S12XEP100 Freescale Semiconductor, DEMO9S12XEP100 Datasheet - Page 1222

• Manufacturer Part Number: DEMO9S12XEP100
• Description: BOARD DEMO FOR MC9S12XEP100
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S12XEP100

• Contents: Board, Cables, CD
• Processor To Be Evaluated: MC9S12XEP100
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12XE
• Rohs Compliant: Yes
• For Use With/related Products: MC9S12XEP100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Appendix A Electrical Characteristics
A.2.2.1
PortAD output drivers switching can adversely affect the ATD accuracy whilst converting the analog
voltage on other PortAD pins because the output drivers are supplied from the VDDA/VSSA ATD supply
pins. Although internal design measures are implemented to minimize the affect of output driver noise, it
is recommended to configure PortAD pins as outputs only for low frequency, low load outputs. The impact
on ATD accuracy is load dependent and not specified. The values specified are valid under condition that
no PortAD output drivers switch during conversion.
A.2.2.2
Due to the input pin leakage current as specified in
there will be a voltage drop from the signal source to the ATD input. The maximum source resistance R
specifies results in an error (10-bit resolution) of less than 1/2 LSB (2.5 mV) at the maximum leakage
current. If device or operating conditions are less than worst case or leakage-induced error is acceptable,
larger values of source resistance of up to 10Kohm are allowed.
A.2.2.3
When sampling an additional internal capacitor is switched to the input. This can cause a voltage drop due
to charge sharing with the external and the pin capacitance. For a maximum sampling error of the input
voltage ≤ 1LSB (10-bit resolution), then the external filter capacitor, C
A.2.2.4
There are two cases to consider.
1222
1. A current is injected into the channel being converted. The channel being stressed has conversion
2. Current is injected into pins in the neighborhood of the channel being converted. A portion of this
values of $3FF (in 10-bit mode) for analog inputs greater than V
V
current is picked up by the channel (coupling ratio K), This additional current impacts the accuracy
of the conversion depending on the source resistance.
RL
unless the current is higher than specified as disruptive condition.
Port AD Output Drivers Switching
Source Resistance
Source Capacitance
Current Injection
MC9S12XE-Family Reference Manual , Rev. 1.23
Table A-8
in conjunction with the source resistance
f
≥ 1024 * (C
RH
and $000 for values less than
INS
Freescale Semiconductor
–C
INN
).
S