DK-EMB-3C120N Altera, DK-EMB-3C120N Datasheet - Page 22

• Manufacturer Part Number: DK-EMB-3C120N
• Description: KIT DEV EMB CYCLONE III EDITION
• Manufacturer: Altera
• Series: Cyclone® IIIr
• Type: FPGAr

Specifications of DK-EMB-3C120N

• Contents: Board, Cables, CD(s), USB-Blaster™, Power Supply
• Architecture: PLD/FPGA
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Cyclone
• Silicon Core Number: EP3C
• Silicon Family Name: Cyclone III
• Rohs Compliant: Yes
• For Use With/related Products: EP3C120
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2589

6–2
Figure 6–1. Board Test System Graphical User Interface
Preparing the Board
Cyclone III FPGA Development Kit User Guide
A GUI runs on the PC which communicates over the JTAG bus to a test design
running in the Cyclone III device.
in the factory configuration.
Several designs are provided to test the major board features. Each design provides
data for one or more tabs in the application. The Configure menu identifies the
appropriate design to download to the FPGA for each tab.
After successful FPGA configuration, the appropriate tab appears and allows you to
exercise the related board features. Highlights appear in the board picture around the
corresponding components.
With the power to the board off, perform the following steps:
1. Connect the USB cable to the board.
2. Verify the settings for the board settings DIP switch bank (SW3) match the settings
in
Table 4–2 on page
4–3.
Figure 6–1
shows the initial GUI for a board that is
September 2010 Altera Corporation
Chapter 6: Board Test System
Preparing the Board