M38000T2-CPE Renesas Electronics America, M38000T2-CPE Datasheet - Page 17

• Manufacturer Part Number: M38000T2-CPE
• Description: EMULATOR BASE UNIT 740
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of M38000T2-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: 740 Family MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M38000T2-CPE User’s Manual
(3) System Reset Switch
By pressing the system reset switch, you can initialize the emulator system.
Table 1.4 shows the functions of the system reset switch depending on the state of the emulator.
Table 1.4 Functions of the system reset switch
(4) LED for Checking the Connections of the Target Status Cables
The LED (LED7) for checking the connections of the target status cables lights only when the Vcc and GND of target status
cables are connected properly. When this LED does not light after turning on the emulator and user system, turn off the power
immediately and check the connections of the target status cables.
However, even under normal operating conditions, when the power supply voltage is less than 3.3 V, the GOOD LED will dim
or will not turn on.
Table 1.5 Definitions of the target status LEDs
R20UT0213EJ0600 Rev.6.00
Oct. 20, 2010
When the user’s program is being stopped
When the user’s program is being executed
GOOD
Notes on a System Reset:
Name
• After pressing the system reset switch, restart the emulator debugger. Otherwise the display of emulator
• When the emulator debugger does not start up normally even after rebooting, turn off the emulator and then turn
Number
State of Emulator
debugger and the actual value (in the emulator) may not match.
on again.
LED7
Green
Color
Status
OFF
ON
VCC and GND of the target status cable are connected properly.
VCC and GND of the target status cable are not connected
properly or power is not supplied.
Initializes the emulator and waits for a command
from the emulator debugger.
Stops the user’s program, initializes the emulator, and
waits for a command from the emulator debugger.
IMPORTANT
Function
Meaning
Page 17 of 82
1. Outline