M38000T2-CPE Renesas Electronics America, M38000T2-CPE Datasheet - Page 34

• Manufacturer Part Number: M38000T2-CPE
• Description: EMULATOR BASE UNIT 740
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of M38000T2-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: 740 Family MCUs
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M38000T2-CPE User’s Manual
3. Usage (How to Use the Emulator Debugger)
This chapter describes how to start up the emulator debugger from the High-performance Embedded Workshop.
3.1 Starting Up the Emulator Debugger
When debugging the completed programs, switch the session. The session can be changed by the drop down list of the tool bar
shown below.
You will have as many sessions created as the number of targets you selected when creating a project, so select the session that
corresponds to the target to be connected from the drop-down list. To connect to the M38000T2-CPE Compact Emulator,
select “Session740_Family_Compact”
(1) MCU tab
1. Specifying the MCU file
R20UT0213EJ0600 Rev.6.00
Oct. 20, 2010
Cancel
Help
Specifying the MCU file
Click the “Refer...” button.
A file selection dialog box will be displayed, so select the
desired MCU file. The MCU file is stored in the directory in
which you installed the High-performance Embedded
Workshop.
(Example: C:\Program Files\Renesas\Hew\Tools\Renesas\
DebugComp\Platform\PDTarget\PD38M\McuFiles)
- The MCU file contains the information specific to the
- The MCU file you have selected is displayed in the MCU
Executing the self-check
Enable this function when you want the emulator to be self-
checked at startup. Be sure to select the check box only
when you want the emulator to be self-checked at startup.
This function may be enabled in the following cases:
- When you successfully download the firmware, but fail
-
This function can be enabled only when you are starting up
the emulator debugger.
For details on the self-check, refer to “2.8 Self-check” on
page 31.
Serial No.
Shows the currently connected emulators in list form. Select
the serial No. of the emulator you want to be connected.
target MCU.
section of the MCU tab.
to start up the emulator
When you want to confirm whether the emulator is
operating normally because, for example, the MCU runs
out of control.
3. Usage (How to Use the Emulator Debugger)
Page 34 of 82