OM11024 NXP Semiconductors, OM11024 Datasheet - Page 15

• Manufacturer Part Number: OM11024
• Description: KIT EVAL FOR LPC313X
• Manufacturer: NXP Semiconductors
• Type: Microcontrollerr

Specifications of OM11024

• Contents: 2 Boards, cable and software
• For Use With/related Products: LPC3131
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-4719

NXP Semiconductors
LPC3130_3131
Preliminary data sheet
6.3 JTAG
6.4 NAND flash controller
The Joint Test Action Group (JTAG) interface allows the incorporation of the
LPC3130/3131 in a JTAG scan chain.
This module has the following features:
The NAND flash controller is used as a dedicated interface to NAND flash devices.
Figure 4
module is formed by a controller block that controls the flow of data from/to the AHB bus
through the NAND flash controller block to/from the (external) NAND flash. An error
correction encoder/decoder (ECC enc/dec) module allows for hardware error correction
for support of Multi-Level Cell (MLC) NAND flash devices.
Before data is written from the buffer to the NAND flash, optionally it is first protected by
an error correction code generated by the ECC module. After data is read from the NAND
flash, the error correction module corrects any errors.
This module has the following features:
Fig 4. Block diagram of the NAND flash controller
•
•
•
•
•
ARM926 debug access
Boundary scan
Dedicated NAND flash interface with hardware controlled read and write accesses.
Wear leveling support with 516 byte mode.
Software controlled command and address transfers to support wide range of flash
devices.
shows a block diagram of the NAND flash controller module. The heart of the
All information provided in this document is subject to legal disclaimers.
Rev. 1.04 — 27 May 2010
AHB MULTILAYER MATRIX
NAND INTERFACE
CONTROLLER
Low-cost, low-power ARM926EJ-S microcontrollers
BUFFER
ENCODER/
DECODER
ECC
DMA transfer request
LPC3130/3131
002aae127
© NXP B.V. 2010. All rights reserved.
15 of 72