45181 Parallax Inc, 45181 Datasheet - Page 151

• Manufacturer Part Number: 45181
• Description: SX TECH TOOL KIT NO POWER
• Manufacturer: Parallax Inc
• Series: SXr
• Type: Microcontrollerr

Specifications of 45181

• Contents: SX Book, SX Key, SX Tech Board, Samples, Resonators, Cable and Manual
• Product: Microcontroller Basic Stamps
• Operating Supply Voltage: 5 V
• For Use With/related Products: SX MCUs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

15.2.1 Instruction Pipeline
There are several stages an instruction must go through to actually execute within the SX chip.
Specifically, there are four stages that are collectively referred to as the pipeline, and are shown in
Figure 20 - Instruction Pipeline. The first instruction is fetched from memory on the first clock cycle.
On the second clock cycle the first instruction is decoded and the second instruction is fetched. On the
third clock cycle the first instruction is executed, the second instruction is decoded, and the third
instruction is fetched. On the fourth clock cycle the first instruction’s results are written to its
destination, the second instruction is executed, the third instruction is decoded and the fourth
instruction is fetched. Once the pipeline is full, instructions are executed at the rate of one per clock
cycle (in Turbo mode). Instructions that directly alter the value in the program counter, i.e. jumps, calls,
etc. require that the pipeline be cleared and subsequently refilled. When the pipeline is cleared, the fetch
and decode stages are replaced with ‘nop’ instructions. This effectively nullifies the invalid instructions
and increases the cycle-time for that command by 3 cycles.
15.2.2 Read-Modify-Write Considerations
Use caution when performing successive SETB or CLRB operations on an I/O port pin. Since input data
used for an instruction must be valid during the time the instruction is executed, and the result output
from an instruction is valid after that instruction completes its operation, unexpected results from
successive read-modify-write operations on I/O pins can occur when the SX is running at extremely
high speeds. The SX has an internal write-back section to prevent such data errors from occurring but it
is recommended that you buffer successive read-modify-write instructions performed on I/O pins of
the same port at extremely high clock rates with a ‘nop’ instruction.
Also note, a read of an I/O pin actually reads the pin, not the output data latch. That is, if an output
driver on a pin is enabled and driven high, but the external circuit is holding it low, a read of the port
pin will indicate that the pin is low. Of course, externally driving an I/O pin while the output latch is
driving it will result in damage to the SX chip. Care should be taken to not do this.
15.2.3 Register Map Structure
The SX20/28 RAM memory consists of a global bank of special function registers and eight banks of 16
general-purpose registers. The SX48/52 RAM memory consists of a global bank of special function
registers and 16 banks of 16 general-purpose registers. Figure 21 – SX20/28 Register Map and Figure 22
Instruction
Stage of
State of
Clock
Cycle 1
Fetch
Clock
Figure 20 - Instruction Pipeline
SX-Key/Blitz Development System Manual 2.0 Parallax, Inc. Page 151
Decode
Cycle 2
Clock
15 Appendix E: SX Data Sheet
Execute
Cycle 3
Clock
Cycle 4
Clock
Write