EVALPM6680 STMicroelectronics, EVALPM6680 Datasheet - Page 32

• Manufacturer Part Number: EVALPM6680
• Description: BOARD EVALUATION FOR PM6680
• Manufacturer: STMicroelectronics

Specifications of EVALPM6680

• Mfg Application Notes: PM6680 Eval Kit, AN2566 App Note
• Main Purpose: DC/DC, Step Down with LDO
• Outputs And Type: 3, Non-Isolated
• Power - Output: 13.25W
• Voltage - Output: 1.05V, 1.5V, 5V
• Current - Output: 5A, 5A, 100mA
• Voltage - Input: 6 ~ 28V
• Regulator Topology: Buck
• Frequency - Switching: 200kHz, 300kHz
• Board Type: Fully Populated
• Utilized Ic / Part: PM6680
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6241

Device description
7.13
7.13.1
7.13.2
32/49
Design guidelines
The design of a switching section starts from two parameters:
●
●
Switching frequency
It's possible to set 3 different working frequency ranges for the two sections with F
(
Switching frequency mainly influences two parameters:
●
●
Inductor selection
Once that switching frequency is defined, inductor selection depends on the desired
inductor ripple current and load transient performance.
Low inductance means great ripple current and could generate great output noise. On the
other hand, low inductor values involve fast load transient response.
A good compromise between the transient response time, the efficiency, the cost and the
size is to choose the inductor value in order to maintain the inductor ripple current ∆I
between 20 % and 50 % of the maximum output current I
occurs at the maximum input voltage. With this considerations, the inductor value can be
calculated with the following relationship:
Equation 12
where f
∆I
In order to prevent overtemperature working conditions, inductor must be able to provide an
RMS current greater than the maximum RMS inductor current I
Equation 13
Where ∆I
Table 7 on page 30
L
is the selected inductor ripple current.
Input voltage range: in notebook applications it varies from the minimum battery
voltage, V
Maximum load current: it is the maximum required output current, I
Inductor size: for a given saturation current and RMS current, greater frequency allows
to use lower inductor values, which means smaller size.
Efficiency: switching losses are proportional to frequency. High frequency generally
involves low efficiency.
SW
L
(max) is the maximum ripple current:
is the switching frequency, V
INmin
).
to the AC adapter voltage, V
I
LRMS
=
L
I (
=
LOAD
V
IN
f
IN
sw
is the input voltage, V
(max))
−
×
V
∆
OUT
I
L
INmax.
2
×
+
V
(
V
OUT
∆
IN
I
L
(max))
12
LOAD
(max). The maximum ∆I
OUT
2
LRMS
is the output voltage and
:
LOAD(max)
.
SEL
PM6680
L
pin
L