MC9RS08KA1CSC Freescale Semiconductor, MC9RS08KA1CSC Datasheet - Page 30

• Manufacturer Part Number: MC9RS08KA1CSC
• Description: IC MCU 8-BIT 1K FLASH 8-SOIC
• Manufacturer: Freescale Semiconductor
• Series: RS08r

Specifications of MC9RS08KA1CSC

• Core Processor: RS08
• Core Size: 8-Bit
• Speed: 10MHz
• Peripherals: LVD, POR, WDT
• Number Of I /o: 4
• Program Memory Size: 1KB (1K x 8)
• Program Memory Type: FLASH
• Ram Size: 63 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (3.9mm Width)
• Processor Series: RS08KA
• Core: RS08
• Data Bus Width: 8 bit
• Data Ram Size: 63 B
• Maximum Clock Frequency: 20 MHz
• Number Of Programmable I/os: 4
• Operating Supply Voltage: 2.7 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: DEMO9RS08KA8, DEMO9RS08KA2
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Connectivity: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Chapter 4 Memory
4.6.2
Programming of Flash memory is done on a row basis. A row consists of 64 consecutive bytes starting
from addresses $3X00, $3X40, $3X80, or $3XC0. Use the following procedure to program a row of Flash
memory:
This program sequence is repeated throughout the memory until all data is programmed.
4.6.3
Use the following procedure to mass erase the entire Flash memory:
30
•
•
1. Apply external V
2. Set the PGM bit. This configures the memory for program operation and enables the latching of
3. Write any data to any Flash location, via the high page accessing window $00C0–$00FF, within
4. Wait for a time, t
5. Set the HVEN bit.
6. Wait for a time, t
7. Write data to the Flash location to be programmed.
8. Wait for a time, t
9. Repeat steps 7 and 8 until all bytes within the row are programmed.
10. Clear the PGM bit.
11. Wait for a time, t
12. Clear the HVEN bit.
13. After time, t
14. Remove external V
1. Apply external V
2. Set the MASS bit in the Flash control register.
Up to 1000 program/erase cycles at typical voltage and temperature
Security feature for Flash
address and data for programming.
the address range of the row to be programmed. (Prior to the data writing operation, the PAGESEL
register must be configured correctly to map the high page accessing window to the corresponding
Flash row).
Flash Programming Procedure
Flash Mass Erase Operation
Flash memory cannot be programmed or erased by software code executed
from Flash locations. To program or erase Flash, commands must be
executed from RAM or BDC commands. User code should not enter wait or
stop during erase or program sequence.
These operations must be performed in the order shown; other unrelated
operations may occur between the steps.
rcv
, the memory can be accessed in read mode again.
nvs
pgs
prog
nvh
PP
PP
.
.
PP
.
.
.
.
.
MC9RS08KA2 Series Data Sheet, Rev. 4
NOTE
Freescale Semiconductor