CB-OWSPA311GI-01 ConnectBlue, CB-OWSPA311GI-01 Datasheet - Page 38

• Manufacturer Part Number: CB-OWSPA311GI-01
• Description: KIT START OEM WIRELESS LAN RS232
• Manufacturer: ConnectBlue
• Series: OEM Serial Port Adapter™r
• Type: Bluetoothr

Specifications of CB-OWSPA311GI-01

• Frequency: 2.4GHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1018

4000
4001
4002
4003
4004
4005
4006
4007
4008
4009
4010
1 = Enabled
Number of milliseconds to wait before stop mode is entered after a valid stop mode condition is
detected. Lowering this value will minimize power consumption but affect system responsive-
ness in a negative way.
0…360000000 (default 600)
Reserved, do not modify.
Reserved, do not modify.
WPA key input mode. Controls how the WPA key is parsed and interpreted.
0 = Auto (default)
1 = ASCII
2 = Hexadecimal
Auto mode will try to determine if it the input is an ASCII key or a HEX key by looking at the
contents.
LED scheme. Can be used to disable the status LED output pins to save power.
0 = LED status always on (default)
1 = LED status disabled when module is in stop mode.
2 = LED status always off
If the module is mounted on a Module Adapter, the always off setting will result in the LED
being red which is the default LED color when the LEDs are not driven by the module.
Put CPU in idle mode. This will conserve power but will but affect system responsiveness and
data throughput in a negative way, especially at baud rates over 230400 bps.
0 = Idle mode off
1 = Idle mode on (default)
Keep remote peers connected when entering AT mode.
0 = Disconnect remote peers (default)
1 = Keep remote peers connected
Configure module to automatically put local peer (UART) in AT mode at startup.
0 = Local peer in data mode at startup (default)
1 = Local peer in AT mode at startup
Ad-hoc timeout. Time before a single unit in an ad-hoc network tries a rescan to find an exist-
ing network. Value in milliseconds.
0 = disabled
0…2147483647 (default 6000)
Delayed association. Time to wait before an association attempt is initiated. Value in millisec-
onds.
0 = no delay
0…2147483647 (default 0)
LLDP send interval. The module will per default send information in LLDP frames with its cur-
rent setup and peers. This can also be used to stay alive on access points that do not properly
wake the module before a disassociation.
Value in seconds.
0 = Do not send.
0…2147483647 (default 60)
Version 1.6.6 - 2009-11
38