SI4330-B1-FMR Silicon Laboratories Inc, SI4330-B1-FMR Datasheet - Page 37

• Manufacturer Part Number: SI4330-B1-FMR
• Description: IC RX ISM 240-960MHZ 20VQFN
• Manufacturer: Silicon Laboratories Inc

Specifications of SI4330-B1-FMR

• Frequency: 240MHz ~ 960MHz
• Sensitivity: -121dBm
• Data Rate - Maximum: 256 kbps
• Modulation Or Protocol: FSK, GFSK, OOK
• Applications: Remote Control, RKE, Security Systems
• Current - Receiving: 18.5mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Features: RSSI Equipped
• Voltage - Supply: 1.8 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-VQFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

(G)FSK AFC Enabled +Antenna Diversity
6.6. Preamble Length
The preamble detection threshold determines the number of valid preamble bits the radio must receive to qualify a
valid preamble. The preamble threshold should be adjusted depending on the nature of the application. The
required preamble length threshold will depend on when receive mode is entered in relation to the start of the
transmitted packet and the length of the transmit preamble. With a shorter than recommended preamble detection
threshold the probability of false detection is directly related to how long the receiver operates on noise before the
transmit preamble is received. False detection on noise may cause the actual packet to be missed. The preamble
detection threshold is programmed in register 35h. For most applications with a preamble length longer than 32 bits
the default value of 20 is recommended for the preamble detection threshold. A shorter Preamble Detection
Threshold may be chosen if occasional false detections may be tolerated. When antenna diversity is enabled a 20-
bit preamble detection threshold is recommended. When the receiver is synchronously enabled just before the
start of the packet, a shorter preamble detection threshold may be used. Table 13 demonstrates the recommended
preamble detection threshold and preamble length for various modes.
It is possible to use the Si4330 in a raw mode without the requirement for a 101010 preamble. Contact customer
support for further details.
Note: The recommended preamble length and preamble detection threshold listed above are to achieve 0% PER. They may
6.7. Invalid Preamble Detector
When scanning channels in a frequency hopping system it is desirable to determine if a channel is valid in the
minimum amount of time. The preamble detector can output an invalid preamble detect signal which can be used
to identify the channel as invalid. After a configurable time set in Register 60h[7:4], an invalid preamble detect
signal is asserted indicating an invalid channel. The period for evaluating the signal for invalid preamble is defined
as (inv_pre_th[3:0] x 4) x Bit Rate Period. The preamble detect and invalid preamble detect signals are available in
"Register 03h. Interrupt/Status 1" and “Register 04h. Interrupt/Status 2” on page 66.
6.8. Synchronization Word Configuration
The synchronization word length for RX can be configured in Reg 33h, synclen[1:0]. The expected or transmitted
sync word can be configured from 1 to 4 bytes as defined below:




The sync is transmitted or expected in the following sequence: sync 3sync 2sync 1sync 0. The sync word
values can be programmed in Registers 36h–39h. After preamble detection, the part will search for sync for a fixed
period of time. If a sync is not recognized in this period, a timeout will occur, and the search for preamble will be re-
(G)FSK AFC Disabled +Antenna Diver-
synclen[1:0] = 00—Expected Synchronization Word (sync word) 3.
synclen[1:0] = 01—Expected Synchronization Word 3 first, followed by sync word 2.
synclen[1:0] = 10—Expected Synchronization Word 3 first, followed by sync word 2, followed by sync word 1.
synclen[1:0] = 1—Expected Synchronization Word 3 first, followed by sync word 2, followed by sync word 1,
followed by sync word 0.
OOK + Antenna Diversity Enabled
be shortened when occasional packet errors are tolerable.
(G)FSK AFC Disabled
(G)FSK AFC Enabled
sity Enabled
Enabled
Mode
OOK
Table 13. Minimum Receiver Settling Time
Settling Time
Approximate
Receiver
1 byte
2 byte
1 byte
2 byte
2 byte
8 byte
Rev 1.0
Recommended preamble
detection threshold
length with 8-bit
20 bits
28 bits
3 byte
—
—
—
Recommended preamble
detection threshold
Si4330-B1
length with 20-bit
32 bits
40 bits
64 bits
8 byte
4 byte
8 byte
37