GS-BT2416C1.AT1 STMicroelectronics, GS-BT2416C1.AT1 Datasheet - Page 28

• Manufacturer Part Number: GS-BT2416C1.AT1
• Description: BLUETOOTH CLASS 1 SPP W/SOFTWARE
• Manufacturer: STMicroelectronics

Specifications of GS-BT2416C1.AT1

• Frequency: 2.4GHz
• Data Rate - Maximum: 721kbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, class 1
• Applications: General Purpose
• Power - Output: 20dBm
• Sensitivity: -84dBm
• Voltage - Supply: 3.3V
• Current - Receiving: 60mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -20°C ~ 70°C
• Package / Case: Module
• Processor Series: STLC2500
• Wireless Frequency: 2.4 GHz to 2.5 GHz
• Interface Type: SPI, I2C, UART, PCM
• Data Rate: 721 Kbps
• Modulation: USB, UART, PCM, SPI, IýC
• Output Power: 100 mW
• For Use With: 497-6224 - DEMO BOARD FOR GS-BT2416C2.ATI497-6223 - DEMO BOARD FOR GS-BT2416C2.H497-5792 - BOARD DEMO FOR CLASS 1 MODULES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-5789

AT command
A.21
A.22
A.23
Note:
28/38
AT+BTMACROSTOP
Stop the programmable status and store the commands sequence inserted so far into the
flash memory of the module. If the sequence is larger then memory block available an error
will be raised. The command will be available only if a device is set to COMMAND MODE
and only if it come after an AT+BTMACROSTART command.
Due to internal time needed to write a flash memory area a little
time delay is possible before any return value.
AT+BTMACROCLEAR
Erase any possible commands sequence present into the flash memory. This operation is
non-reversible.
AT+BTCONNECT
Initiate an SPP connection to a remote Bluetooth
successfully established the command returns an OK message and GPIO1 is set to high.
It is possible to specify a number of attempts and a time interval between any retry. It also
possible to stop a sequence of connections retry changing the state of GPIO3 (as with the
startup Macro).
When connected with another device the module become “Non-Connectable” and “Non-
Discoverable”.
Syntax: AT+BTMACROSTOP
Return value: <OK, ERROR>
Syntax: AT+BTMACROCLEAR
Return value: <OK, ERROR>
®
device. When the connection has been
GS-BT2416C1.AT1