LIS331DLFTR STMicroelectronics, LIS331DLFTR Datasheet - Page 29

• Manufacturer Part Number: LIS331DLFTR
• Description: ACCELEROMETER MEMS 3AXIS 16-LGA
• Manufacturer: STMicroelectronics
• Series: MEMS, nanor

Specifications of LIS331DLFTR

• Featured Product: STM32 Cortex-M3 Companion Products
• Axis: X, Y, Z
• Acceleration Range: ±2g, 4g, 8g
• Sensitivity: 16LSB/g, 8LSB/g, 4LSB/g
• Voltage - Supply: 2.16 V ~ 3.6 V
• Output Type: Digital
• Bandwidth: 100Hz ~ 400Hz Selectable
• Interface: I²C, SPI
• Mounting Type: Surface Mount
• Package / Case: 16-LGA
• Sensing Axis: X, Y, Z
• Acceleration: 2 g, 4 g, 8 g
• Digital Output - Number Of Bits: 6 bit
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.16 V
• Supply Current: 250 uA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Digital Output - Bus Interface: I2C, SPI
• Mounting Style: SMD/SMT
• Shutdown: Yes
• For Use With: 497-10048 - BOARD EVAL ACCELEROMETER
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

LIS331DLF
7.6
7.7
7.8
Table 29.
CTRL_REG5 (24h)
Table 30.
Table 31.
TurnOn bits are used for turning on the sleep to wake function.
HP_FILTER_RESET (25h)
Dummy register. Reading at this address zeroes instantaneously the content of the internal
high pass-filter. If the high pass filter is enabled all three axes are instantaneously set to 0g.
This allows to overcome the settling time of the high pass filter.
REFERENCE (26h)
Table 32.
Table 33.
This register sets the acceleration value taken as a reference for the high-pass filter output.
When filter is turned on (at least one of FDS, HPen2, or HPen1 bit is equal to ‘1’) and HPM
bits are set to “01”, filter out is generated taking this value as a reference.
FS1, FS0
STsign
ST
SIM
TurnOn1,
TurnOn0
Ref7 - Ref0
Ref7
0
CTRL_REG4 description
CTRL_REG5 register
CTRL_REG5 description
REFERENCE register
REFERENCE description
Full-scale selection. Default value: 00.
(00: ±2 g; 01: ±4 g; 11: ±8 g)
Self-test sign. Default value: 00.
(0: self-test plus; 1 self-test minus)
Self-test enable. Default value: 0.
(0: self-test disabled; 1: self-test enabled)
SPI serial interface mode selection. Default value: 0.
(0: 4-wire interface; 1: 3-wire interface)
Turn-on mode selection for sleep to wake function. Default value: 00.
Reference value for high-pass filter. Default value: 00h.
Ref6
0
Ref5
0
Doc ID 15101 Rev 4
Ref4
0
Ref3
0
Ref2
0
Register description
TurnOn1
Ref1
TurnOn0
Ref0
29/38