COP8SGR728M8 National Semiconductor, COP8SGR728M8 Datasheet - Page 26

• Manufacturer Part Number: COP8SGR728M8
• Description: 8-Bit Microcontroller IC
• Manufacturer: National Semiconductor
• Series: COP8r

Specifications of COP8SGR728M8

• Controller Family/series: COP8
• Core Size: 8 Bit
• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Package: 28SOIC W
• Family Name: COP8
• Maximum Speed: 15 MHz
• Ram Size: 512 Byte
• Program Memory Size: 32 KB
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 8 Bit
• Program Memory Type: EPROM
• Number Of Programmable I/os: 40
• Interface Type: USART
• Operating Temperature: -40 to 85 °C
• Number Of Timers: 4
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

www.national.com
7.0 Power Saving Features
7.2 IDLE MODE
The device is placed in the IDLE mode by writing a “1” to the
IDLE flag (G6 data bit). In this mode, all activities, except the
associated on-board oscillator circuitry and the IDLE Timer
T0, are stopped.
As with the HALT mode, the device can be returned to
normal operation with a reset, or with a Multi-Input Wakeup
from the L Port. Alternately, the microcontroller resumes
normal operation from the IDLE mode when the twelfth bit
(representing 4.096 ms at internal clock frequency of
10 MHz, t
This toggle condition of the twelfth bit of the IDLE Timer T0 is
latched into the T0PND pending flag.
The user has the option of being interrupted with a transition
on the twelfth bit of the IDLE Timer T0. The interrupt can be
enabled or disabled via the T0EN control bit. Setting the
T0EN flag enables the interrupt and vice versa.
C
= 1 µs) of the IDLE Timer toggles.
FIGURE 18. Wakeup from HALT
FIGURE 19. Wakeup from IDLE
(Continued)
26
The user can enter the IDLE mode with the Timer T0 inter-
rupt enabled. In this case, when the T0PND bit gets set, the
device will first execute the Timer T0 interrupt service routine
and then return to the instruction following the “Enter Idle
Mode” instruction.
Alternatively, the user can enter the IDLE mode with the
IDLE Timer T0 interrupt disabled. In this case, the device will
resume normal operation with the instruction immediately
following the “Enter IDLE Mode” instruction.
Note: It is necessary to program two NOP instructions following both the set
HALT mode and set IDLE mode instructions. These NOP instructions
are necessary to allow clock resynchronization following the HALT or
IDLE modes.
10131725
10131726