CQM1-CIF01 Omron, CQM1-CIF01 Datasheet - Page 111

• Manufacturer Part Number: CQM1-CIF01
• Description: PERIPHERAL CABLE FOR NEC COMP.
• Manufacturer: Omron

Specifications of CQM1-CIF01

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Test Run
Executing JOG
Operations
Executing Direct
Operations
90
1,2,3...
1,2,3...
Note
Note
1. Click the JOG Operation Tab.
2. Select the axis to be jogged.
3. If the RUN signal allocation for the axis is set to Valid in the Test Run Set-
4. Enter the acceleration time, deceleration time, speed, and override value
5. Execute the JOG operation with the JOG Buttons.
6. If an error occurs in the axis, the error code will be displayed. Click the Re-
1. Click the Direct Operation Tab.
(1) Executing a JOG operation will operate the motor at the designated
(2) The operation on the personal computer may not stop the motor. Provide
(1) Executing a direct operation will operate the motor at the designated
(2) The operation on the personal computer may not stop the motor. Provide
tings Window (refer to 8-1 Test Run Settings), the RUN Signal ON Button
can be used. (If the RUN signal allocation is set to Invalid, the RUN Signal
ON Button will be disabled as shown in the above window.)
Click the RUN Signal ON Button to turn ON the RUN signal.
in the JOG Setting Area, and then click the Apply Button. Clicking this but-
ton is required before executing the JOG operation.
set Button in the Axis Error Area to clear the error.
If the drive alarm reset signal is allocated in the Test Run Settings Window
(refer to 8-1 Test Run Settings), the drive alarm will be cleared as well.
speed. Execute these operations only after confirming safety.
an emergency stop device externally to enable stopping the motor imme-
diately at any time.
speed. Execute direct operations only after confirming safety.
an emergency stop device externally to enable stopping the motor imme-
diately at any time.
Section 8-2