CP-BNCPC-017 Emerson Network Power, CP-BNCPC-017 Datasheet - Page 214

• Manufacturer Part Number: CP-BNCPC-017
• Manufacturer: Emerson Network Power
• Type: BNCr

Specifications of CP-BNCPC-017

• Gender: RCP
• Body Style: Right Angle
• Terminate To: PCB
• Mounting Style: Through Hole
• Termination: Solder
• Operating Temp Range: -55C to 85C
• Operating Frequency: 0 to 4
• Body Plating: Nickel
• Contact Plating: Gold
• Contact Material: Brass/BeCu
• Body Material: Zinc/Brass
• Impedance: 50Ohm
• Lead Free Status / RoHS Status: Compliant

214
Assembly Instructions
INCHES (MILLIMETERS) • CUSTOMER DRAWINGS AVAILABLE ON REQUEST
MCX Solder Type Straight Plug
for Semi-Rigid Cable
Connectivity Solutions
Tel: [phone]
•
Fax: [phone]
•
www.EmersonNetworkPower.com/connectivity
1. Identify connector parts. (2 piece parts)
2. Strip cable to dimensions shown. Do not
3. Place center contact on center conductor
4. Insert contact and cable into body assembly
nick center conductor.
making sure contact bottoms against cable
insulation. Solder center conductor to
center contact through solder hole. Solder
must not be allowed to run on outside of
contact. Use a minimum amount of solder
for a good joint. .020 (0.51) diameter
solder is recommended. Trim excess
insulation.
making sure cable is bottomed against
insulator in body. Solder body to cable. Use
a minimum amount of heat to minimize
cable insulation movement.
(.086 Semi-Rigid)
CABLE TYPE
RG-405/U
133-3693-001
133-3693-006
PART NO.