DK-PCIE-ECP2M-011 Lattice, DK-PCIE-ECP2M-011 Datasheet - Page 8

• Manufacturer Part Number: DK-PCIE-ECP2M-011
• Description: MCU, MPU & DSP Development Tools PCI Express Dev Kit
• Manufacturer: Lattice
• Series: ECP2r

Specifications of DK-PCIE-ECP2M-011

• Silicon Manufacturer: Lattice Semiconductor
• Silicon Family Name: LatticeECP2M
• Kit Contents: Board, IspDOWNLOAD Cable, Power Supply
• Features: Logic Analyzer Connector, On-Board 256 MB DDR2 Memory
• Svhc: No
• Rohs Compliant: Yes
• Main Purpose: Interface, Connectivity
• Embedded: Yes, FPGA / CPLD
• Utilized Ic / Part: LFE2M50E-6FN672C
• Primary Attributes: x1/x4 PCI Express Edge Connectors, 256 MB DDRD Memory
• Secondary Attributes: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Lattice Semiconductor
Download Procedures
Requirements:
• PC with ispVM System v.16.0 (or later) programming management software, installed with appropriate drivers
• ispDOWNLOAD Cable (pDS4102-DL2A, HW7265-DL3A, HW-USB-1A, etc.)
JTAG Download
The LatticeECP2M device can be configured easily via its JTAG port. The device is SRAM-based; it must remain
powered on to retain its configuration when programmed in this fashion.
1. Connect the LatticeECP2M PCI Express Solutions Board to the appropriate power sources and power up
2. Connect the ispDOWNLOAD cable to the appropriate header. J3 is used for the 1x8 connection. J11 is used in
3. Start the ispVM System software.
4. Press the SCAN button located in the toolbar. The LatticeECP2M and the MachXO1200 devices should be
Figure 7. ispVM Main Window
5. Double-click the device to open the device information dialog. In the device information dialog, click the Browse
6. To program only the LatticeECP2M-50, place the LCMXO1200C device into BYPASS and the LFE2M50E
(USB driver for USB Cable, Windows NT/2000/XP parallel port driver for ispDOWNLOAD Cable).
Note: An option to install these drivers is included as part of the ispVM System setup.
board.
the same manner for x4 configurations.
automatically detected.
button located under Data File. Locate the desired bitstream file (.bit). Click OK to both dialog boxes.
should be in FAST PROGRAM mode.
8
LatticeECP2M PCI Express Solutions Board
User’s Guide