EPM7064STC100-6 Altera, EPM7064STC100-6 Datasheet - Page 18

• Manufacturer Part Number: EPM7064STC100-6
• Description: MAX 7000/S/AE/B
• Manufacturer: Altera

MAX 7000 Programmable Logic Device Family Data Sheet
Programming
with External
Hardware
18
f
f
Open-Drain Output Option (MAX 7000S Devices Only)
MAX 7000S devices provide an optional open-drain (functionally
equivalent to open-collector) output for each I/O pin. This open-drain
output enables the device to provide system-level control signals (e.g.,
interrupt and write enable signals) that can be asserted by any of several
devices. It can also provide an additional wired-OR plane.
By using an external 5.0-V pull-up resistor, output pins on MAX 7000S
devices can be set to meet 5.0-V CMOS input voltages. When V
3.3 V, setting the open drain option will turn off the output pull-up
transistor, allowing the external pull-up resistor to pull the output high
enough to meet 5.0-V CMOS input voltages. When V
the output drain option is not necessary because the pull-up transistor will
already turn off when the pin exceeds approximately 3.8 V, allowing the
external pull-up resistor to pull the output high enough to meet 5.0-V
CMOS input voltages.
Slew-Rate Control
The output buffer for each MAX 7000E and MAX 7000S I/O pin has an
adjustable output slew rate that can be configured for low-noise or high-
speed performance. A faster slew rate provides high-speed transitions for
high-performance systems. However, these fast transitions may introduce
noise transients into the system. A slow slew rate reduces system noise,
but adds a nominal delay of 4 to 5 ns. In MAX 7000E devices, when the
Turbo Bit is turned off, the slew rate is set for low noise performance. For
MAX 7000S devices, each I/O pin has an individual EEPROM bit that
controls the slew rate, allowing designers to specify the slew rate on a
pin-by-pin basis.
MAX 7000 devices can be programmed on Windows-based PCs with the
Altera Logic Programmer card, the Master Programming Unit (MPU),
and the appropriate device adapter. The MPU performs a continuity
check to ensure adequate electrical contact between the adapter and the
device.
For more information, see the
The Altera development system can use text- or waveform-format test
vectors created with the Text Editor or Waveform Editor to test the
programmed device. For added design verification, designers can
perform functional testing to compare the functional behavior of a
MAX 7000 device with the results of simulation. Moreover, Data I/O, BP
Microsystems, and other programming hardware manufacturers also
provide programming support for Altera devices.
For more information, see the
Altera Programming Hardware Data
Programming Hardware
CCIO
Manufacturers.
Altera Corporation
is 5.0 V, setting
CCIO
Sheet.
is