ISP1507CBS,518 NXP Semiconductors, ISP1507CBS,518 Datasheet - Page 41

• Manufacturer Part Number: ISP1507CBS,518
• Description: RF Transceiver USB 2.0 ULPI TRNSCVR
• Manufacturer: NXP Semiconductors

Specifications of ISP1507CBS,518

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Single
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Lead Free Status / RoHS Status: Compliant
• Other names: 935285496518 ISP1507CBS-T

NXP Semiconductors
ISP1507C_ISP1507D_1
Product data sheet
9.12.1 OTG comparators
9.12.2 Pull-up and pull-down resistors
9.12.3 V
9.13 Serial modes
The ISP1507 provides comparators that conform to On-The-Go Supplement to the
USB 2.0 Specification Rev. 1.3 requirements of V
and V
V
are communicated to the link by RXCMDs as described in
comparators is described in
The USB resistors on DP and DM can be used to initiate data-line pulsing SRP. The link
must set the required bus state using mode settings given in
A pull-up resistor, R
allowed to charge V
the V
A pull-down resistor, R
whenever the A-device turns off the V
resistor to ensure V
For details, refer to On-The-Go Supplement to the USB 2.0 Specification Rev. 1.3 .
The ISP1507 supports both 6-pin serial mode and 3-pin serial mode, controlled by
bits 6PIN_FSLS_SERIAL and 3PIN_FSLS_SERIAL of the INTF_CTRL register (see
Section
Rev. 1.1, Section 3.10 .
Figure 18
respectively.
B_SESS_VLD
BUS
BUS
B_SESS_END
charge and discharge resistors
10.1.3). For details, refer to UTMI+ Low Pin Interface (ULPI) Specification
power.
and
. Comparators are described in
Figure 19
. In this data sheet, V
BUS
UP(VBUS)
BUS
DN(VBUS)
Rev. 01 — 28 May 2008
is below V
above the session valid threshold to request the host to turn on
provide examples of 6-pin serial mode and 3-pin serial mode,
, is provided to perform V
Section 10.1.5
, is provided for a B-device to discharge V
B_SESS_END
BUS
A_SESS_VLD
ULPI HS USB host and peripheral transceiver
power. The B-device can use the pull-down
to
Section
ISP1507C; ISP1507D
before starting a session.
Section
A_VBUS_VLD
and V
7.6. Changes in comparator values
BUS
10.1.8.
B_SESS_VLD
pulsing SRP. A B-device is
Section
, V
Table
A_SESS_VLD
9.5.2.2. Control over
7.
are combined into
© NXP B.V. 2008. All rights reserved.
BUS
, V
. This is done
B_SESS_VLD
40 of 74