ISP1507DBSUM STEricsson, ISP1507DBSUM Datasheet - Page 41

• Manufacturer Part Number: ISP1507DBSUM
• Manufacturer: STEricsson

Specifications of ISP1507DBSUM

• Lead Free Status / RoHS Status: Compliant

CD00222690
Product data sheet
9.12.1 OTG comparators
9.12.2 Pull-up and pull-down resistors
9.12.3 V
9.13 Serial modes
The ISP1507 provides comparators that conform to On-The-Go Supplement to the
USB 2.0 Specification Rev. 1.3 requirements of V
and V
V
are communicated to the link by RXCMDs as described in
comparators is described in
The USB resistors on DP and DM can be used to initiate data-line pulsing SRP. The link
must set the required bus state using mode settings given in
A pull-up resistor, R
allowed to charge V
the V
A pull-down resistor, R
whenever the A-device turns off the V
resistor to ensure V
For details, refer to On-The-Go Supplement to the USB 2.0 Specification Rev. 1.3.
The ISP1507 supports both 6-pin serial mode and 3-pin serial mode, controlled by
bits 6PIN_FSLS_SERIAL and 3PIN_FSLS_SERIAL of the INTF_CTRL register (see
Section
Rev. 1.1, Section 3.10.
Figure 18
respectively.
B_SESS_VLD
BUS
BUS
B_SESS_END
charge and discharge resistors
10.1.3). For details, refer to UTMI+ Low Pin Interface (ULPI) Specification
power.
and
. Comparators are described in
Figure 19
. In this data sheet, V
BUS
UP(VBUS)
BUS
DN(VBUS)
Rev. 04 — 20 May 2010
is below V
above the session valid threshold to request the host to turn on
provide examples of 6-pin serial mode and 3-pin serial mode,
, is provided to perform V
Section 10.1.5
, is provided for a B-device to discharge V
B_SESS_END
BUS
A_SESS_VLD
ULPI HS USB host and peripheral transceiver
power. The B-device can use the pull-down
to
Section
ISP1507C; ISP1507D
before starting a session.
Section
A_VBUS_VLD
and V
7.6. Changes in comparator values
BUS
10.1.8.
B_SESS_VLD
pulsing SRP. A B-device is
Section
, V
Table
A_SESS_VLD
9.5.2.2. Control over
7.
are combined into
© ST-ERICSSON 2010. All rights reserved.
BUS
, V
. This is done
B_SESS_VLD
41 of 73