DS14285SN Maxim Integrated Products, DS14285SN Datasheet - Page 8

• Manufacturer Part Number: DS14285SN
• Description: IC RTC W/NV RAM CNTRL IND 24SOIC
• Manufacturer: Maxim Integrated Products
• Type: Clock/Calendar/NVSRAMr

Specifications of DS14285SN

• Memory Size: 114B
• Time Format: HH:MM:SS (12/24 hr)
• Date Format: YY-MM-DD-dd
• Interface: Parallel
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 24-SOIC (7.5mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DS14285/DS14287
RTC ADDRESS MAP
The address map of the DS14285/DS14287 is shown in Figure 2. The address map consists of 114 bytes
of user RAM, 10 bytes of RAM that contain the RTC time, calendar, and alarm data, and 4 bytes which
are used for control and status. All 128 bytes can be directly written or read except for the following:
1. Registers C and D are read-only.
2. Bit 7 of Register A is read-only.
3. The high order bit of the seconds byte is read-only.
The contents of four registers (A,B,C, and D) are described in the “Registers” section.
Figure 2. DS14285/DS14287 Address Map
TIME, CALENDAR AND ALARM LOCATIONS
The time and calendar information is obtained by reading the appropriate memory bytes. The time,
calendar, and alarm are set or initialized by writing the appropriate RAM bytes. The contents of the 10
time, calendar, and alarm bytes can be either Binary or Binary-Coded Decimal (BCD) format. Before
writing the internal time, calendar, and alarm registers, the SET bit in Register B should be written to a
logic 1 to prevent updates from occurring while access is being attempted. In addition to writing the 10
time, calendar, and alarm registers in a selected format (binary or BCD), the data mode bit (DM) of
Register B must be set to the appropriate logic level. All 10 time, calendar, and alarm bytes must use the
same data mode. The set bit in Register B should be cleared after the data mode bit has been written to
allow the real-time clock to update the time and calendar bytes. Once initialized, the real-time clock
makes all updates in the selected mode. The data mode cannot be changed without reinitializing the 10
data bytes. Table 1 shows the binary and BCD formats of the ten time, calendar, and alarm locations. The
8 of 26