AD7822BRU Analog Devices Inc, AD7822BRU Datasheet - Page 16

• Manufacturer Part Number: AD7822BRU
• Description: IC ADC 8BIT 1CH 2MSPS 20TSSOP
• Manufacturer: Analog Devices Inc

Specifications of AD7822BRU

• Rohs Status: RoHS non-compliant
• Number Of Bits: 8
• Sampling Rate (per Second): 2M
• Data Interface: Parallel
• Number Of Converters: 1
• Power Dissipation (max): 36mW
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 20-TSSOP (0.173", 4.40mm Width)

AD7822/AD7825/AD7829
Mode 2 Operation (Automatic Power-Down)
When the AD7822/AD7825/AD7829 are operated in Mode 2
(see Figure 25), they automatically power down at the end of
a conversion. The CONVST signal is brought low to initiate
a conversion and is left logic low until after the EOC goes high,
that is, approximately 100 ns after the end of the conversion.
The state of the CONVST signal is sampled at this point (that is,
530 ns maximum after CONVST falling edge), and the AD7822/
AD7825/AD7829 power down as long as CONVST is low.
DB0 TO DB7
CONVST
DB0 TO DB7
EOC
CONVST
RD
CS
EOC
RD
CS
TRACK
t
t
POWER-UP
2
120ns
HOLD
t
1
t
1
Figure 24. Mode 1 Operation
Figure 25. Mode 2 Operation
Rev. C | Page 16 of 28
The ADC is powered up again on the rising edge of the
CONVST signal. Superior power performance can be achieved
in this mode of operation by powering up the AD7822/AD7825/
AD7829 only to carry out a conversion. The parallel interface of
the AD7822/AD7825/AD7829 remains fully operational while
the ADCs are powered down. A read may occur while the part
is powered down, and, therefore, it does not necessarily need to
be placed within the EOC pulse, as shown in Figure 25.
TRACK
VALID
DATA
VALID
DATA
POWER
DOWN
HERE
t
3
HOLD