20-101-1105 Rabbit Semiconductor, 20-101-1105 Datasheet - Page 11

• Manufacturer Part Number: 20-101-1105
• Description: MODULE RCM4100 RABBITCORE
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1105

• Module/board Type: MPU Core Module
• Data Bus Width: 8 bit
• For Use With/related Products: RCM4100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1121

2.1 Install Dynamic C
To develop and debug programs for the RCM4100 series (and for all other Rabbit hard-
ware), you must install and use Dynamic C.
If you have not yet installed Dynamic C version 10.01 (or a later version), do so now by
inserting the Dynamic C CD from the RCM4100 Development Kit in your PC’s CD-ROM
drive. If autorun is enabled, the CD installation will begin automatically.
If autorun is disabled or the installation does not start, use the Windows
or Windows Disk Explorer to launch
The installation program will guide you through the installation process. Most steps of the
process are self-explanatory.
Dynamic C uses a COM (serial) port to communicate with the target development system.
The installation allows you to choose the COM port that will be used. The default selec-
tion is COM1. You may select any available port for Dynamic C’s use. If you are not cer-
tain which port is available, select COM1. This selection can be changed later within
Dynamic C.
Once your installation is complete, you will have up to three new icons on your PC desk-
top. One icon is for Dynamic C, one opens the documentation menu, and the third is for
the Rabbit Field Utility, a tool used to download precompiled software to a target system.
If you have purchased any of the optional Dynamic C modules, install them after installing
Dynamic C. The modules may be installed in any order. You must install the modules in
the same directory where Dynamic C was installed.
User’s Manual
This chapter describes the RCM4100 series in more detail, and
explains how to set up and use the accompanying Prototyping Board.
NOTE: This chapter (and this manual) assume that you have the RCM4100 Development
NOTE: The installation utility does not check the selected COM port in any way. Speci-
Kit. If you purchased an RCM4100 module by itself, you will have to adapt the infor-
mation in this chapter and elsewhere to your test and development setup.
fying a port in use by another device (mouse, modem, etc.) may lead to a message such
as "could not open serial port" when Dynamic C is started.
setup.exe
2. G
from the root folder of the CD-ROM.
ETTING
S
Start | Run
TARTED
menu
7