20-101-1105 Rabbit Semiconductor, 20-101-1105 Datasheet - Page 23

• Manufacturer Part Number: 20-101-1105
• Description: MODULE RCM4100 RABBITCORE
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1105

• Module/board Type: MPU Core Module
• Data Bus Width: 8 bit
• For Use With/related Products: RCM4100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1121

•
•
•
User’s Manual
SIMPLE3WIRE.C
communication. Lower case characters are sent by TxC, and are
received by RxD. The characters are converted to upper case and are
sent out by TxD, are received by RxC, and are displayed in the
Dynamic C
To set up the Prototyping Board, you will need to tie TxD and RxC together on the
RS-232 header at J4, and you will also tie RxD and TxC together using the jumpers
supplied in the Development Kit as shown in the diagram.
SIMPLE5WIRE.C
with flow control on Serial Port D and data flow on Serial Port C.
To set up the Prototyping Board, you will need to tie TxD and RxD
together on the RS-232 header at J4, and you will also tie TxC and
RxC together using the jumpers supplied in the Development Kit as
shown in the diagram.
Once you have compiled and run this program, you can test flow con-
trol by disconnecting TxD from RxD while the program is running. Characters will no
longer appear in the
back to RxD.
If you have two Prototyping Boards with modules, run this sample program on the
sending board, then disconnect the programming cable and reset the sending board so
that the module is operating in the Run mode. Connect TxC, TxD, and GND on the
sending board to RxC, RxD, and GND on the other board, then, with the programming
cable attached to the other module, run the sample program. Once you have compiled
and run this program, you can test flow control by disconnecting TxD from RxD as
before while the program is running.
SWITCHCHAR.C
ASCII string on Serial Ports C and D. It also displays the serial data received from both
ports in the
To set up the Prototyping Board, you will need to tie TxD and RxC
together on the RS-232 header at J4, and you will also tie RxD and
TxC together using the jumpers supplied in the Development Kit as
shown in the diagram.
Once you have compiled and run this program, press and release
switches S2 and S3 on the Prototyping Board. The data sent between the serial ports
will be displayed in the
STDIO
STDIO
—This program demonstrates transmitting and then receiving an
—This program demonstrates basic RS-232 serial
—This program demonstrates 5-wire RS-232 serial communication
window.
window.
STDIO
STDIO
window, and will display again once TxD is connected
window.
19