20-101-0709 Rabbit Semiconductor, 20-101-0709 Datasheet - Page 16

• Manufacturer Part Number: 20-101-0709
• Description: INTERFACE GRAPHIC DISPLAY OP6700
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0709

• Module/board Type: Single Board Computer Module
• For Use With/related Products: OP6700
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-709; 20-101-709

2.3 Programming Cable Connections
1. Connect the programming cable to the Intellicom board.
Connect the 10-pin
com board as shown in Figure 4. Be sure to orient the red edge of the cable towards pin 1 of
the connector. (Do not use the
2. Apply power.
Reset the Intellicom by unplugging the AC adapter, then plugging it back in. The Intelli-
com board is now ready to be used.
To power down the Intellicom, unplug the AC adapter. You should disconnect power
before making any circuit adjustments or changing any connections to the board.
12
NOTE: Never disconnect the programming cable by pulling on the ribbon cable.
NOTE: Some PCs now come equipped only with a USB port. It may be possible to use an
NOTE: Be sure to use the programming cable (Part No. 101-0513) supplied with the
NOTE: A hardware RESET is accomplished by unplugging the AC adapter, then plug-
Carefully pull on the connector to remove it from the header.
RS-232/USB converter (Part No. 20-151-0178) with the programming cable supplied
with the Intellicom Tool Kit. Note that not all RS-232/USB converters work with
Dynamic C.
Intellicom Tool Kit—the programming cable has red shrink wrap around the RS-232
converter section located in the middle of the cable. Programming cables from other
Rabbit kits are not designed to work with the Intellicom.
ging it back in.
PROG
Figure 4. Programming Cable Connections
connector of the programming cable to header J4 on the Intelli-
DIAG
connector, which is used for a normal serial connection.)
Intellicom (OP6600/OP6700)