20-101-0709 Rabbit Semiconductor, 20-101-0709 Datasheet - Page 49

• Manufacturer Part Number: 20-101-0709
• Description: INTERFACE GRAPHIC DISPLAY OP6700
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0709

• Module/board Type: Single Board Computer Module
• For Use With/related Products: OP6700
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-709; 20-101-709

5.1 TCP/IP Connections
Before proceeding you will need to have the following items.
• If you don’t have Ethernet access, you will need at least a 10Base-T Ethernet card
• Two RJ-45 straight through Ethernet cables and a hub, or an RJ-45 crossover Ethernet
The Ethernet cables and Ethernet hub are available from Rabbit in a TCP/IP tool kit. More
information is available at www.rabbit.com.
1. Connect the AC adapter and the programming cable as shown in Chapter 2, “Getting
2. Ethernet Connections
• If you do not have access to an Ethernet network, use a crossover Ethernet cable to con-
• If you have an Ethernet connection, use a straight-through Ethernet cable to establish
3. Apply Power
Plug in the AC adapter. The Intellicom board is now ready to be used.
When working with the Intellicom board, the green
running and the board is properly connected either to an Ethernet hub or to an active Eth-
ernet card. The red
User’s Manual
(available from your favorite computer supplier) installed in a PC.
cable.
Started.”
nect the Intellicom to a PC that at least has a 10Base-T Ethernet card.
an Ethernet connection to the Intellicom from an Ethernet hub. These connections are
shown in Figure 15.
Chapter 5 provides an introduction to using the TCP/IP features
on your Intellicom.
NOTE: A hardware RESET is accomplished by unplugging the AC adapter,
then plugging it back in.
5. U
ACT
light flashes each time a packet is received.
SING THE
TCP/IP F
LNK
light is on when a program is
EATURES
45