20-101-0709 Rabbit Semiconductor, 20-101-0709 Datasheet - Page 64

• Manufacturer Part Number: 20-101-0709
• Description: INTERFACE GRAPHIC DISPLAY OP6700
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0709

• Module/board Type: Single Board Computer Module
• For Use With/related Products: OP6700
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-709; 20-101-709

B.1 Keypad Insert
The keypad is designed to accept paper inserts prepared on regular paper. The templates
shown below in Figure B-1 can be used to create custom inserts. The numbers shown on
the upper template correspond to the codes returned by Dynamic C when that key is
pressed.
These instructions describe how to change the keypad insert.
1. Set the outer plastic casing aside and lay the front panel face down on a soft cloth so
2. Unplug the speaker and the keypad as shown in Figure B-2.
3. Remove the four screws shown in Figure B-2 that hold the Intellicom board to the front
4. Lift the Intellicom board up front the front panel and set it aside. Note that the LCD is
5. Remove the four screws shown in Figure B-3 that hold the keypad to the front panel.
6. Remove the old insert and place the new insert in between the keypad and the mylar
7. Line up the keypad over the front panel and replace the four 2-56 screws as shown in
60
that the Intellicom board is facing up.
panel.
attached permanently to the Intellicom board.
front. You may tape down the portion of the insert that extends beyond the keypad.
Figure B-3. Line up the Intellicom board/LCD and replace the four screws as shown in
Figure B-2. Reconnect the keypad and the speaker to the Intellicom board.
Figure B-1. Intellicom 2 × 6 Keypad Template
Intellicom (OP6600/OP6700)