20-101-0709 Rabbit Semiconductor, 20-101-0709 Datasheet - Page 69

• Manufacturer Part Number: 20-101-0709
• Description: INTERFACE GRAPHIC DISPLAY OP6700
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0709

• Module/board Type: Single Board Computer Module
• For Use With/related Products: OP6700
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-709; 20-101-709

B.2.1.2 Supplied Outer Casing
Once the desired wires have been connected to header J7 on the Intellicom board, the
Intellicom may be mounted in the plastic outer casing as shown in Figure B-8. Secure the
plastic casing with the six screws supplied with the Intellicom
The outer casing has a knockout for a conduit on one side. The casing is symmetric, and so
the conduit knockout can face up or down. Use a small hacksaw to remove the knockout if
you are using a conduit. The conduit opening has an O.D. of 0.826 inches (21.0 mm),
which accommodates standard trade size ½ or 17 mm diameter conduit.
When routing cables through the conduit, our has found that an Ethernet cable (minus the
rubber boot on the RJ-45 plug) should be routed first, followed by the RS-485 cable with
the RJ-12 plug, followed by other wire.
User’s Manual
If you are using the RJ-45 jack at J6
for an Ethernet connection with the
Intellicom installed in the plastic
outer casing, remove the protective
rubber boot around the Ethernet
cable RJ-45 jack that plugs into the
Intellicom board. This will ensure
that the Ethernet cable can bend
back within the depth of the plastic
outer casing.
Figure B-8. Mounting Intellicom in Plastic Outer Casing
Figure B-9. Remove Rubber Boot from RJ-45
Connection to Intellicom
65