ISL59440IAZ-T7 Intersil, ISL59440IAZ-T7 Datasheet - Page 11

IC AMP 400MHZ MULTIPLEX 16-QSOP

ISL59440IAZ-T7

Manufacturer Part Number
ISL59440IAZ-T7
Description
IC AMP 400MHZ MULTIPLEX 16-QSOP
Manufacturer
Intersil
Datasheet

Specifications of ISL59440IAZ-T7

Applications
4:1 Multiplexer-Amplifier
Number Of Circuits
1
-3db Bandwidth
400MHz
Slew Rate
1470 V/µs
Current - Supply
14.5mA
Current - Output / Channel
130mA
Mounting Type
Surface Mount
Package / Case
16-QSOP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
ISL59440IAZ-T7TR
PC Board Layout
The frequency response of this circuit depends greatly on
the care taken in designing the PC board. The following are
recommendations to achieve optimum high frequency
performance from your PC board.
• The use of low inductance components such as chip
• Match channel-channel analog I/O trace lengths and
• Maximize use of AC de-coupled PCB layers. All signal I/O
• Use proper value and location of termination resistors.
• When testing use good quality connectors and cables,
• Minimum of 2 power supply de-coupling capacitors are
• The NIC pins are placed on both sides of the input pins.
resistors and chip capacitors is strongly recommended.
layout symmetry. This will minimize propagation delay
mismatches.
lines should be routed over continuous ground planes (i.e.
no split planes or PCB gaps under these lines). Avoid vias
in the signal I/O lines.
Termination resistors should be as close to the device as
possible.
matching cable types and keeping cable lengths to a
minimum.
recommended (1000pF, 0.01µF) as close to the device as
possible - Avoid vias between the cap and the device
because vias add unwanted inductance. Larger caps can
be farther away. When vias are required in a layout, they
should be routed as far away from the device as possible.
These pins are not internally connected to the die. It is
recommended these pins be tied to ground to minimize
crosstalk.
11
ISL59440
October 10, 2007
FN6162.2

Related parts for ISL59440IAZ-T7