STM32F102C8 STMicroelectronics, STM32F102C8 Datasheet - Page 26

• Manufacturer Part Number: STM32F102C8
• Description: Mainstream USB Access line, ARM Cortex-M3 MCU with 64 Kbytes Flash, 48 MHz CPU, USB FS
• Manufacturer: STMicroelectronics

Specifications of STM32F102C8

• Core: ARM 32-bit Cortex™-M3 CPU
• Peripherals Supported: timers, ADC, SPIs, I2Cs and USARTs
• Conversion Range: 0 to 3.6 V
• Systick Timer: 24-bit downcounter

Electrical characteristics
26/69
Table 6.
1. All main power (V
2. I
3. Negative injection disturbs the analog performance of the device. See note in
4. When several inputs are submitted to a current injection, the maximum I
Table 7.
I
INJ(PIN)
I
supply, in the permitted range.
cannot be respected, the injection current must be limited externally to the I
injection is induced by V
characteristics.
positive and negative injected currents (instantaneous values). These results are based on
characterization with I
INJ(PIN)
Symbol
INJ(PIN)
Symbol
I
I
VDD
VSS
I
T
IO
STG
T
J
(2)(3)
must never be exceeded. This is implicitly insured if V
(2)
Current characteristics
Thermal characteristics
Total current into V
Total current out of V
Output current sunk by any I/O and control pin
Output current source by any I/Os and control pin
Injected current on NRST pin
Injected current on High-speed external OSC_IN and Low-
speed external OSC_IN pins
Injected current on any other pin
Total injected current (sum of all I/O and control pins)
DD
, V
Storage temperature range
Maximum junction temperature
DDA
INJ(PIN)
IN
>V
) and ground (V
DD
maximum current injection on four I/O port pins of the device.
while a negative injection is induced by V
Doc ID 15056 Rev 3
DD
SS
/V
Ratings
SS
DDA
ground lines (sink)
, V
Ratings
SSA
power lines (source)
) pins must always be connected to the external power
(4)
IN
maximum is respected. If V
(1)
STM32F102x8, STM32F102xB
(1)
INJ(PIN)
IN
<V
INJ(PIN)
(4)
Section 5.3.16: 12-bit ADC
SS
–65 to +150
is the absolute sum of the
.
value. A positive
Value
150
Max.
 25
± 25
150
150
± 5
± 5
± 5
25
IN
maximum
Unit
Unit
°C
°C
mA